Cisco Catalyst IW6300 Series Kurulum Kılavuzu - Sayfa 22
Kablosuz Erişim Noktası Cisco Catalyst IW6300 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco Catalyst IW6300 Series 28 sayfaları. Product document of compliance
Ayrıca Cisco Catalyst IW6300 Series için: Başlarken (20 sayfalar)
Sayfayı Yazdır
Connecting an Ethernet Cable to the Access Point
Note
Tip
Step 3
Ensure that the antennas are connected and that a ground is attached to the access point before you apply
power to the access point.
Step 4
Ensure that the power injector is grounded. See the power injector installation guide for details:
https://www.cisco.com/c/en/us/td/docs/wireless/access_point/power/guide/air_pwrinj_60rgd.html
Step 5
Connect a shielded outdoor-rated Ethernet (CAT5e or better) cable between the power injector and the PoE
In connector of the access point.
Step 6
Connect the Ethernet cable to the access point PoE IN port (see
Point, on page
Note
Connecting an Ethernet Cable to the Access Point
The following tools and materials are required:
• Shielded outdoor-rated Ethernet (CAT5e or better) cable
Note
The Ethernet cable from the power injector to the access point must be at least 10 ft (3.05 m) long.
• RJ-45 connector and installation tool
• Adjustable wrench
• Ex-certified cable gland or conduit
To connect the shielded Ethernet cable to the access point, follow these steps:
Procedure
Step 1
Disconnect power to the power injector, and ensure all power sources to the access point are turned off.
Step 2
Ensure a 6 AWG ground wire is connected to the access point (see
Step 3
Use a 3/8" Allen wrench to remove the 1/2" NPT Ethernet connector plug from the access point.
Step 4
Insert the unterminated end of the Ethernet cable into the conduit, and pull several inches of cable through
the conduit.
Step 5
Install an RJ-45 connector on the unterminated end of the Ethernet cable using your Ethernet cable installation
tool.
Warning
Installing the Access Point
22
The installer is responsible for ensuring that powering the access point from this type of power
injector is allowed by local and/or national safety and telecommunications equipment standards.
To forward bridge traffic, add a switch between the power injector and controller. Refer to the latest
Cisco Wireless Mesh Access Points, Design and Deployment Guide for more information.
22).
When the access point is powered by PoE+ or UPoE, the PoE Out power is disabled. But the PoE
Out data link can still be active.
To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord. Statement
1023
Installing the Access Point
Connecting an Ethernet Cable to the Access
Grounding the Access Point , on page
19).