■
Allow space behind the product for the cables, and space above the product so that you can
fully raise the document cover.
■
Leave enough space in front of the product for the paper to be fully ejected.
■
Leave enough room around the product for sufficient ventilation. Make sure the product is at
least 4 inches (10 cm) away from the wall.
■
Do not block or cover openings in the product case or insert objects through the slots.
■
Do not use aerosol products that contain flammable gases inside or around the product. Doing
so may cause fire.
■
Do not press too hard on the document table when placing the originals.
■
Do not open the scanner section while the product is faxing, copying, printing, or scanning.
■
Be careful not to trap your fingers when closing the scanner cover or scanner.
■
Do not touch the flat white cable inside the product.
■
Do not spill liquid on the product. Do not use the product near water. Do not use with wet
hands.
■
Unplug the product and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally or
exhibits a distinct change in performance.
■
Adjust only those controls that are covered by the operating instructions. Except as specifically
explained in your documentation, do not attempt to service the product yourself.
■
Never disassemble, modify, or attempt to repair the product by yourself, except as specifically
explained in the documentation. Do not adjust controls that are not covered by the operating
instructions.
■
When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside
down; otherwise ink may leak from the cartridges.
■
Always keep this guide handy.
Touch Panel Safety Instructions
■
Press the touch panel gently with your fingertip. Do not press with force or use your fingernail.
■
Do not use items such as ball point pens, pencils, etc. to operate the touch panel.
■
Do not place heavy items on the touch panel. Contact Epson if the panel chips or cracks; do
not attempt to remove broken pieces.
■
Do not place your product in areas where abrupt changes in temperature or humidity may
occur. Condensation inside the panel may cause performance to deteriorate.
■
Do not touch the panel with wet or gloved hands or through the protective sheet or sticker; it
may not respond.
■
Use only a dry, soft cloth to clean the touch panel. Do not use liquid or chemical cleansers.
37
Notices
Sayfayı Yazdır