Cisco Meraki CW9162I-MR Donanım Kurulum Kılavuzu - Sayfa 8

Kablosuz Erişim Noktası Cisco Meraki CW9162I-MR için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Cisco Meraki CW9162I-MR 23 sayfaları.

Sayfayı Yazdır

3.4 Assigning IP Addresses to CW9162I-MR

All gateway CW9162I-MR (CW9162I-MR with Ethernet connections to the LAN) must be assigned

routable IP addresses. These IP addresses can be dynamically assigned via DHCP or statically

assigned.

3.4.1 Dynamic Assignment

When using DHCP, the DHCP server should be configured to assign a static IP address for each

MAC address belonging to a Meraki AP. Other features of the wireless network such as 802.1x

authentication, may rely on the property that the APs have static IP addresses.

3.4.2 Static Assignment

Static IPs are assigned using the local web server on each AP. The following procedure describes

how to set the static IP:

1. Using a client machine (e.g. a laptop), connect to the AP either wirelessly (by associating to

any SSID broadcast by the AP) or over a wired connection.

If using a wired connection, connect the client machine to the CW9162I-MR either through a PoE

switch or a Meraki PoE Injector. If using a PoE switch, plug an Ethernet cable into the CW9162I-

MR's Ethernet jack, and the other end into a PoE switch. Then connect the client machine over

Ethernet cable to the PoE switch. If using a Meraki PoE Injector, connect the CW9162I-MR to the

"PoE" port of the Injector, and the client machine to the "LAN" port.

2. Using a web browser on the client machine, access the AP's built-in web server by

browsing to http://my.meraki.com. Alternatively, browse to http://10.128.128.128.

3. Click on the "Static IP Configuration" tab. Log in. The default username is "admin". The default

password is the AP's serial number, with hyphens included

4. Configure the static IP address, net mask, gateway IP address and DNS servers that this AP will

use on its wired connection.

5. If necessary, reconnect the AP to the LAN.

3.4.3 Static IP via DHCP Reservations

Instead of associating to each Meraki AP individually to configure static IP addresses, an administrator can

assign static IP addresses on the upstream DHCP server. Through "DHCP reservations", IP addresses

are "reserved" for the MAC addresses of the Meraki APs. Please consult the documentation for the DHCP

server to configure DHCP reservations.