Cisco Meraki MR46 Kurulum Kılavuzu - Sayfa 13

Kablosuz Erişim Noktası Cisco Meraki MR46 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco Meraki MR46 18 sayfaları.

Tip: Pre-assemble rubber spacers and screws to the mount cradle. The mount cradle can then be held with one hand

while the other hand holds a screwdriver. If mounting your AP to a dropped ceiling, skip to the "Power the AP" section.

Electrical Junction Box Mount Using Mount Cradle

The access point can be mounted to a 4" square cable junction box, a 3.5 or 4" round cable junction box, or various U.S.

and European outlet boxes (mounting screws are not included).

Using appropriate mounting hardware for your specific type of junction box, attach the mount cradle to the junction box.

Getting Power to the AP

If mounting to an electrical junction box, feed the Ethernet cable through the cable access hole in the mount cradle. If

mounting to a wall or ceiling, the Ethernet cable will feed from behind the AP. The

"Power Source

Options" section of

this document lists the different powering options and their unique characteristics.

Mount the AP

Attach the MR46 AP to the Mount Cradle

(This section applies to wall and/or solid ceiling, drop ceiling or electrical junction box mount where you have already

installed the mount cradle.)

The MR46 AP attaches to the mount cradle with two tabs on the cradle that insert into the MR46 AP, and is secured to

the cradle using one screw.

To attach the MR46 AP to the mount cradle properly, line up the top edge of the AP with the top tab of the mount cradle.

Since the cradle is already mounted to the wall, guide the MR46 AP towards the top tab and insert the top tab into the

MR46 AP's slot.