Cisco WAP150 Hızlı Başlangıç Kılavuzu - Sayfa 3

Kablosuz Erişim Noktası Cisco WAP150 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco WAP150 13 sayfaları. Reboot and reset to factory default settings
Ayrıca Cisco WAP150 için: Manuel (4 sayfalar)

Sayfayı Yazdır

Cisco WAP150 Features

Front Panel

The front panel of the Cisco WAP150 consists of one system LED. For full

descriptions of the colors of the lights and their indications, see

the Hardware

Installation.

Back Panel

RESET—See

Rebooting the Cisco WAP150 or Resetting to Factory

Defaults

for information on the RESET button.

LAN (PoE)—The RJ-45 Ethernet port is used to power the Cisco WAP150

using PoE. It is an auto-sensing, Gigabit Ethernet (802.3) port used to

connect the Cisco WAP150 to network devices, such as computers,

routers, or switches. We strongly recommend that you use a Category

5e or better cable for Gigabit connectivity.

POWER—The POWER button is used to turn the power on and off. It is not

applicable when using PoE.

12V DC—The 12V DC jack is used to connect the supplied power adapter

to the Cisco WAP150 if you are not using PoE.

Kensington Lock Slot—The Kensington lock slot is used to attach a cable

and lock to the Cisco WAP150.

Default Settings

Parameter

Username

Password

LAN IP Address

Fallback LAN IP

Subnetwork Mask

If you are using a Cisco RV Series router, the default range for the DHCP

assigned address is from 192.168.1.100 to 192.168.1.254. Any device

connecting to the same LAN will be assigned an IP address in this range.

Mounting the Cisco WAP150

There are two ways to physically install the Cisco WAP150:

Cisco WAP150 Quick Start Guide

Default Value

cisco

DHCP address assigned by server

192.168.1.245

255.255.255.0

Verifying