Cisco WAP321 Hızlı Başlangıç Kılavuzu - Sayfa 3

Kablosuz Erişim Noktası Cisco WAP321 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco WAP321 13 sayfaları. Reboot and reset to factory default settings
Ayrıca Cisco WAP321 için: İnceleme (6 sayfalar), Veri Sayfası (8 sayfalar), Broşür ve Teknik Özellikler (4 sayfalar), Hızlı Başlangıç Kılavuzu (13 sayfalar), Manuel (4 sayfalar), Manuel (4 sayfalar)

Sayfayı Yazdır

Cisco WAP121 and WAP321 Wireless-N

Access Point Features

Front Panel

The front panel of the devices consists of three lights: Power, WLAN, and

LAN. For full descriptions of the colors of the lights and their indications,

see

"Verifying the Hardware

under the lights.

Back Panel

The back panel of the devices consists of:

• Power Button—Use this button to turn the power on and off. It is not

applicable when using PoE.

• Power Jack—Use this jack if you are not using PoE.

• Kensington Lock Slot—Use to attach a cable and lock to the device.

• Reset—See

Factory Default Settings"

• RJ-45 Ethernet Port—Use this auto-sensing, Gigabit Ethernet (802.3)

port to connect to network devices, such as computers, routers, or

switches. Cisco strongly recommends using Cat5 or better cable for

Gigabit connectivity. You may use the Ethernet port to power your

device using PoE.

Default Settings

Parameter

Username

Password

LAN IP Address

Fallback LAN IP

Subnetwork Mask

If you are using a Cisco Small Business RV Series router, the default range

for the DHCP assigned address is from 192. 1 68. 1 . 1 00 to 192. 1 68. 1 .254. Any

device connecting to the same LAN will be assigned an IP address in this

range.

Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE

Installation". A Kensington lock slot is found

"Rebooting the Devices or Returning them to their

for information on the Reset button.

Default Value

cisco

DHCP address assigned

by server

192. 1 68. 1 .245

255.255.255.0