Cisco WAP351 Hızlı Başlangıç Kılavuzu - Sayfa 3

Kablosuz Erişim Noktası Cisco WAP351 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco WAP351 13 sayfaları. Reboot and reset factory default settings
Ayrıca Cisco WAP351 için: Manuel (4 sayfalar), Fabrika Ayarlarına Sıfırlama (4 sayfalar)

Sayfayı Yazdır
Cisco WAP351 Hızlı Başlangıç Kılavuzu
PD—The Powered Device (PD) port is used to power the Cisco WAP351
using PoE.
PSE—The Power Sourcing Equipment (PSE) port is used to power the
device that is connected to the Cisco WAP351 through this port.
LAN1-5—The RJ-45 Ethernet port is an auto-sensing, Gigabit Ethernet
(802.3) port used to connect theCisco WAP351to network devices, such
as computers, routers, or switches. We strongly recommend that you use
a Category 5e or better cable for gigabit connectivity.

Side Panel

The side panel of the Cisco WAP351 has a Kensington lock slot. You can
use it to attach a cable and lock to the Cisco WAP351.

Default Settings

Parameter
Username
Password
LAN IP Address
Fallback LAN IP
Subnetwork Mask
If you are using a Cisco RV Series router, the default range for the DHCP
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.

Mounting the Cisco WAP351

3
There are two ways to physically install the Cisco WAP351:
• Place the Cisco WAP351 horizontally on a flat surface so that it sits on
its four rubber feet.
• Mount the Cisco WAP351 to a wall or ceiling.

Placement Tips

• Ambient Temperature—To prevent the Cisco WAP351 from
overheating, do not operate it in an area that exceeds an ambient
temperature of 104°F (40°C).
• Air Flow—Both side panels have vents that must be unobstructed to
prevent overheating.
Cisco WAP351 Quick Start Guide
Default Value
cisco
cisco
DHCP address assigned by server
192.168.1.245
255.255.255.0
3