Cisco 7821 Manuel - Sayfa 6

Change the Viewing Angle of Your Phone

Procedure

Step 1

Remove the handset from the cradle and pull the plastic tab from the handset rest.

Step 2

Rotate the tab 180 degrees.

Step 3

Hold the tab between two fingers, with the corner notches facing you.

Step 4

Line up the tab with the slot in the cradle and press the tab evenly into the slot. An extension protrudes from

the top of the rotated tab.

Step 5

Return the handset to the handset rest.

Change the Viewing Angle of Your Phone

You can change the angle of the phone, except the Cisco IP Phone 7811, to eliminate glare on the screen.

Procedure

Step 1

Unplug the phone from the network.

Step 2

Place the phone so that the keypad faces the desktop.

Step 3

Grasp one side of the footstand with one hand and place your other hand on the phone.

Step 4

Hold down the phone and pull up on the footstand.

Step 5

Turn the footstand over.

Step 6

Push the footstand back into the phone until the stand locks into place.

Step 7

Place the phone upright and plug it into the network.

Connect to the Network

You need to connect the phone to the network.

• Wired network connection—The phone is plugged into the network with an Ethernet cable.

After connecting the phone to the network, your phone may be set up for:

• Mobile and Remote Access Through Expressway—If your administrator sets up Mobile and Remote

Share a Network Connection with Your Phone and Computer

Both your phone and your computer must connect to your network to function. If you only have one Ethernet

port, then your devices can share the network connection.

Your Phone

Access Through Expressway and you connect your phone to the network, it connects to the Expressway

server.

Your Phone