Epson ET-2750 series Buradan başlayın - Sayfa 2

Hepsi Bir Arada Yazıcı Epson ET-2750 series için çevrimiçi göz atın veya pdf Buradan başlayın indirin. Epson ET-2750 series 4 sayfaları. How to load dye sublimation ink on 4 colors epson ecotank printer
Ayrıca Epson ET-2750 series için: Başlangıç Kılavuzu (2 sayfalar), Hızlı Kılavuz (21 sayfalar)

Sayfayı Yazdır

When the ink tank is full, remove the ink bottle and

securely close the ink tank cap. Place the remaining ink

aside; you will need it later.

Note:

Replace the bottle cap and tighten it.

Repeat the previous steps for the other colors.

Close the ink tank cover and then the scanner unit.

Connect the power cord to the back of the product and to

an electrical outlet.

Caution:

Do not connect to your computer yet.

Raise the control panel, then press the

turn on the product.

Note:

If an error message appears, turn off the product and

check that no protective material has been left inside the product.

Press

to select your language on the LCD screen,

then press the OK button. Follow steps 11 and 12 to

continue ink charging.

Note:

You can change this setting later using the product's

control panel. For more information, see the online User's Guide.

When the message to see the Start Here sheet appears

on the LCD screen, press the OK button. On the next

screen, press and hold the

power button to

help button for 3 seconds.

When the message to start initialization appears on the

LCD screen, press the

the ink. Ink charging takes approximately 10 minutes. A

message appears when ink charging is complete. Press

the OK button to continue.

Note:

After some ink is used for charging, the rest is available for

printing.

Caution:

Do not turn off the product, raise the scanner unit, or

load paper while the product is charging or you'll waste ink.

To complete filling the ink tanks, repeat steps 1 through 6

using the remaining ink in the bottles.

Note:

Replace the bottle cap before disposing of the bottles.

Close the ink tank cover and scanner unit.

Select Maintenance > Reset Ink Levels, then follow the

on-screen instructions to reset the ink levels.

Follow the on-screen instructions to adjust the print

quality. Press the OK button to continue.

Note:

You can change these settings later using the product's

control panel. For more information, see the online User's Guide.

Load paper

See the online User's Guide for information about loading

capacity and available paper types and sizes.

Make sure the product is not charging. Then flip the

feeder guard forward, raise the paper support, and tilt it

backwards slightly.

Slide the edge guides all the way out.

start button to start charging