Cisco Codec C Series Başlangıç Kılavuzu - Sayfa 29

Konferans Sistemi Cisco Codec C Series için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco Codec C Series 46 sayfaları. Telepresence conference system
Ayrıca Cisco Codec C Series için: Başlangıç Kılavuzu (41 sayfalar), Kullanıcı Kılavuzu (44 sayfalar), Başlangıç Kılavuzu (35 sayfalar), Başlangıç Kılavuzu (32 sayfalar), Başlangıç Kılavuzu (42 sayfalar)

Sayfayı Yazdır

Cisco TelePresence Video Systems

Contents

Setup assistant for SX10

When you start the system for the first time, the Setup assistant

starts automatically.

On first time setup, you will be prompted for a software upgrade.

We recommend that you wait for the software upgrade message

and upgrade before you continue on the setup assistant.

•

If you do decide to upgrade mid setup, changes to the

settings will not persist.

•

If you choose to postpone the software upgrade, you will

be prompted again in six hours.

If your system is automatically provisioned, the IP and provision-

ing settings are automatically configured. To keep the automatic

settings, skip these stages on the Setup assistant.

Start the Setup assistant

Navigate to the upper left corner on the home screen and press

on the remote control.

Navigate to

Settings

and press OK. Navigate to

and press OK. Follow the instructions on screen.

If the system does not show a menu on screen:

•

Make sure the monitor is connected and has been switched

on.

•

Make sure that the correct input is selected on the monitor.

•

Make sure the remote control has batteries installed.

•

Make sure the system is switched on.

If the system has just been switched on, wait a few minutes to

allow the system to start up.

If there is still no menu on screen, make sure the monitor cable

is connected to the video output connector. If in doubt, see the

installation guide for your product.

Back to task overview

D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.

Introduction

User interfaces

Setup assistant

Configuration

On-screen display

Getting Started Guide

Appendices

Contacts