Cable Electronics CE LABS HSW88C Kullanım Kılavuzu - Sayfa 9

Matris Anahtarlayıcı Cable Electronics CE LABS HSW88C için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Cable Electronics CE LABS HSW88C 11 sayfaları. 8x8 hdmi over cat5 matrix with ir pass-through

Sayfayı Yazdır
Definition of IR Earphone Jack
1 = IR signal (38KHz)
2 = Grounding
The IR extension cables are standard market configuration.
You can buy From CE labs if necessary for replacement use.
Supported IR Data Format
Data Format
Suitable
NEC
RC5
TOSHIBA MICOM
CODE
GRUNDIG CODE
SONY 12 BIT CODE
SONY 15 BIT CODE
SONY 20 BIT CODE
RCA CODE
RCM CODE
MATSUSHITA CODE
MITSUBISHI CODE
ZENITH CODE
JVC CODE
M50560-001P
MN6125H
MN6125L
MN6014_C5D7
MN6014-C6D6
MC14457P
LC7464(AHEA)
GEMINI_CM
1 = Power
2 = IR signal (38KHz)
3 - Grounding
Not
Recommended

DIP SWITCH

SW1-SW8 for EDID/Audio
DIP Switch Position
Video
Audio
Pin#1
Pin#2
Up to
OFF [ ]
OFF [ ]
Stereo
1080p
Up to
OFF [ ]
ON [ ]
720p /
Stereo
1080i
ON [ ]
OFF [ ]
Bypass
4
Bypass
ON [ ]
ON [ ]
Bypass
Stereo
Note:
1. If the HDTV shows video but without audio, please try to set
audio mode to stereo.
2. Factory default setting of [SW1]-[SW8] is pin#1-OFF[ ] &
pin#2- OFF[ ] for 1080p with stereo.
3. If you encounter any unsolved audio/video output problem
during system installation, please turn any [SW1]-[SW8] to
pin#1-OFF[ ] & pin#2-ON[ ] for safe mode to enforce the
most compatible 720p stereo output for system check.
However, the safe mode cannot be initiated if your HDMI
source is set to enforce 1080p output. In this case, please
reconfigure your HDMI source to all resolution output for
troubleshooting.
4. Bypass means the matrix will maintain playing the original
format of HDMI signals in video and perhaps audio. By
setting at this mode, the users may encounter compatibility
issue among different kinds of HDMI sources and displays. If
you cannot get the audio and/or video output normally at
the system installation, please change the DIP switch setting
to default mode or even safe mode to verify the
functionality of the device.
5. To learn the EDID of HDMI display for respective HDMI source
devices, please see the [EDID Learning] section in the next
page for more detail information.
Description
Default Mode
– Up to 1080p & stereo audio output for
2
1
most HDTVs
Safe Mode
– Enforce the system output at 720p/1080i
3
video and stereo audio for basic compatibility among
HDTVs
EDID Learning Mode
– for learning EDID from the
5
4
display while playing any received HDMI audio format
EDID Learning & Stereo Mode
5
– for learning EDID from
the display while enforcing stereo output if any HDTV
cannot play surround sound normally