Cisco MeetingPlace Audio Server 5.2 Yükseltme Kılavuzu - Sayfa 12
Konferans Sistemi Cisco MeetingPlace Audio Server 5.2 için çevrimiçi göz atın veya pdf Yükseltme Kılavuzu indirin. Cisco MeetingPlace Audio Server 5.2 20 sayfaları. Telepresence conference system
Ayrıca Cisco MeetingPlace Audio Server 5.2 için: Kullanıcı Kılavuzu (44 sayfalar), Başlangıç Kılavuzu (46 sayfalar)
Sayfayı Yazdır
How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM
If the server does not boot up (you cannot get into the Setup mode on the monitor), contact Cisco TAC
as described in the
"Replacing the CPU and Updating the License Keys" section on page
In Setup mode, press the right arrow to choose the Advanced menu.
Step 5
By using the Down arrow, choose IDE Configuration and press Enter.
Step 6
Verify that the Local Bus IDE field is set to Both, as shown in
Step 7
Do not save when you are prompted.
Note
Figure 12
If the Cisco MeetingPlace 8112 comes up after exiting the BIOS, proceed to the
Step 8
DVD-ROM Drive into the Cisco MeetingPlace 8112" section on page
or
If the server does not come up after exiting the BIOS, contact Cisco TAC as described in the
Technical Assistance" section on page 18
the License Keys" section on page
Replacing the CPU and Updating the License Keys
To replace the CPU and update the license keys, perform the following steps:
Obtain new license keys by contacting Cisco TAC.
Step 1
Verify that the power is off on the Cisco MeetingPlace 8112 and your laptop is connected to the service
Step 2
port on the front of the server with the null-modem cable.
Remove the old CPU card and replace it with the new CPU card.
Step 3
Place the old CPU card in the anti-static bag from which you removed the new CPU card.
Step 4
Power up the server.
Step 5
Log in as a technician.
Step 6
Step 7
Check for alarms.
Step 8
Verify that there is a modem line connected to the server.
Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure
12
"Obtaining Technical Assistance" section on page 18
IDE Configuration Screen
12.
Figure
before you proceed to the
before you proceed to the
12.
12. To exit, press ESC.
Should be set
to"Both"
"Installing the
7.
"Obtaining
"Replacing the CPU and Updating
78-16489-01