Argo AW752CL Kullanım Talimatları Kılavuzu - Sayfa 3

Klima Argo AW752CL için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Argo AW752CL 16 sayfaları.

NAME OF PARTS AND OPERATION SELECTOR SWITCH

1. Remote control unit.

2. Remote control sensor: Detects the room temperature

around the remote control unit, the air conditioner is

controlled accordingly.

3. Air outlet: Conditioned air is blown out of the air

conditioner through the air outlet.

4. Air intake: Air from the room is drawn into this section

and passes through air filter which removes dust.

5. Remote control receiver: This section picks up infrared

signals from the remote control unit (Transmitter).

6. Operation selector (without remote control): Push

the button to walk through the operation modes:

COOLING Models

OFF and COOL

HEAT PUMP Models

OFF, COOL and HEAT

WARNING

The OFF position does not disconnect the power. Use

the main power switch to turn off power completely.

7. OPERATION lamp: This lamp lights up during operation.

It blinks once to announce that the remote control signal

has been received and stored. It blinks continuously

during the protection modes (defrosting, etc.).

7 8

8. STANDBY lamp: This lamp lights up when the air

conditioner is connected to the power and ready to

receive the remote control command.

9. TIMER lamp: This lamp lights up when the system is

being controlled by the timer.

10.Air intake latch, on two sides.

11.Air filter.

12.Suspension brackets.

13.Refrigerant couplings.

14.Condensate drain connection.

15.Sensor: Detects the room temperature around the unit;

when the remote control unit is not active the air

conditioner will be set by the detected temperature.

COOLING Models

NOTE

The blinking of OPERATION, TIMER and STANDBY

lamps, indicates that the operating mode selected is not

compatible with the unit. If this happen the air

conditioner does not operate until the correct mode is

selected.

only