DigiTech BASS SYNTH WAH Manuel - Sayfa 14

Müzik Pedalı DigiTech BASS SYNTH WAH için çevrimiçi göz atın veya pdf Manuel indirin. DigiTech BASS SYNTH WAH 17 sayfaları. Bass envelope filter

Battery Replacement

1. Using the tip of a 1/4" cable, push one of the release pins in on

either side of the pedal, and remove the pedal from the pedal

chassis.

2. Remove the battery from the battery compartment and

disconnect the battery cable.

3. Connect a new battery to the battery cable and put it back in the

battery compartment. Make sure the battery cable does not

interfere with the spring or pedal switch arm.

4. Place one hole of the pedal over its corresponding pin.

5. Push the opposite pin in and lower the other side of the pedal

into place over the depressed pin. Release the pin. When the

pedal is properly fastened, both release pins are flush with the

outer side of the pedal.