Epson L3110 Series Hızlı Kılavuz - Sayfa 5

Hepsi Bir Arada Yazıcı Epson L3110 Series için çevrimiçi göz atın veya pdf Hızlı Kılavuz indirin. Epson L3110 Series 48 sayfaları.
Ayrıca Epson L3110 Series için: Buradan başlayın (4 sayfalar), Hızlı Kılavuz (40 sayfalar), Hızlı Kılavuz (48 sayfalar), Hızlı Kılavuz (48 sayfalar), Hızlı Kılavuz (36 sayfalar), Buradan başlayın (2 sayfalar)

Reading the Indication Lights

: On

: Flashing

Normal Status

The printer is connected to a wireless (Wi-Fi) network.

The printer is connected to a network in Wi-Fi Direct (Simple AP) mode.

Error Status

Wi-Fi connection error has occurred. Press the

Initial ink charging may not be complete. See the Start Here to complete initial ink charging.

No paper is loaded or more than one sheet has been fed at a time. Load paper and press the

button.

A paper jam has occurred. Remove the paper and press the

& "Clearing Paper Jam" on page 45

If the indicator light continues flashing, see the jammed paper section from "Solving Problems" in the

User's Guide.

The printer was not turned off correctly. After clearing the error by pressing the

cancel any pending print jobs. We recommend performing a nozzle check because the nozzles may

have dried or clogged.

To turn off the printer, make sure you press the

O Flashing simultaneously: An ink pad is nearing or at the end of its service life.

O Flashing alternately: A borderless printing ink pad is nearing or at the end of its service life.

Borderless printing is not available, but printing with a border is available.

To replace the ink pad or borderless printing ink pad, contact Epson or an authorized Epson service

provider.

The printer has started in recovery mode because the firmware update failed.

For more details, see the error indicator table from "Solving Problems" in the User's

Guide.

A printer error has occurred. Open the front cover and remove any paper inside the

printer. Turn the power off and on again. If the error continues to occur after turning

the power off and on again, contact Epson support.

button to clear the error and try again.

button.

button,