Cisco Profile Series Kurulum Kılavuzu - Sayfa 38

Konferans Sistemi Cisco Profile Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco Profile Series 44 sayfaları. Jbod on the 12g sas modular raid controller
Ayrıca Cisco Profile Series için: Başlangıç Kılavuzu (41 sayfalar), Kullanıcı Kılavuzu (44 sayfalar), Kullanıcı Kılavuzu (7 sayfalar), Başlangıç Kılavuzu (35 sayfalar), Hızlı Referans Kılavuzu (2 sayfalar), Yapılandırma Kılavuzu (13 sayfalar), Kurulum Sayfası (2 sayfalar), Kurulum Kılavuzu (2 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar), Kurulum Kılavuzu (16 sayfalar), Başlangıç Kılavuzu (32 sayfalar), Manuel (16 sayfalar), Başlangıç Kılavuzu (42 sayfalar), Başlangıç Kılavuzu (46 sayfalar)

Sayfayı Yazdır

Set up a console connection to your router, and enter privileged EXEC mode.

Step 1

In privileged EXEC mode, at the prompt, enter setup.

Step 2

yourname# setup

The following message is displayed:

--- System Configuration Dialog ---

Continue with configuration dialog? [yes/no]:

You are now in the setup command facility.

The prompts in the setup command facility vary, depending on your router model, on the installed

interface modules, and on the software image. The following steps and the user entries (in bold) are

shown as examples only.

Note

Step 3

To proceed using the setup command facility, enter yes.

Continue with configuration dialog? [yes/no]: yes

Step 4

When the following messages appear, enter yes to enter basic management setup.

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Basic management setup configures only enough connectivity

for management of the system, extended setup will ask you

to configure each interface on the system

Would you like to enter basic management setup? [yes/no]: yes

Enter a hostname for the router (this example uses Router).

Step 5

Configuring global parameters:

Enter host name [Router]: Router

Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when

Step 6

viewing the configuration.

The enable secret is a password used to protect access to

privileged EXEC and configuration modes. This password, after

entered, becomes encrypted in the configuration.

Enter enable secret: xxxxxx

Enter an enable password that is different from the enable secret password. This password is not

Step 7

encrypted (less secure) and can be seen when viewing the configuration.

The enable password is used when you do not specify an

enable secret password, with some older software versions, and

some boot images.

Enter enable password: xxxxxx

Cisco 800M Series Integrated Services Router Hardware Installation Guide

4-2

If you make a mistake while using the setup command facility, you can exit and run the setup

command facility again. Press Ctrl-C, and enter the setup command at the privileged EXEC

mode prompt (Router#). For more information on using the setup command facility, see

Setup Command"

chapter in

Release

12.2T.

Cisco IOS Configuration Fundamentals Command Reference,

Chapter 4

Initial Configuration

"The