DigiTech JAMMAN - MANUAL 2 Kullanıcı El Kitabı - Sayfa 14
Müzik Pedalı DigiTech JAMMAN - MANUAL 2 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. DigiTech JAMMAN - MANUAL 2 20 sayfaları. Remote foot controller
Using the Control 2 Remote Foot Controller
When you load a preset, some effects may already be on. Those effects will
have a lit LED next to their footswitch(es).
To turn effects on or off using Footswitches 6-10, follow these steps:
1.
Make sure the Control 2 is in 5 Patch Mode (see page 5 for instructions
on how to switch modes).
2.
Press one of the footswitches numbered 6-10. The footswitch's LED
turns on to indicate the effect is active, or turns off to indicate the effect
is bypassed.
Bounce Back
Bounce Back allows switching between two presets using a single footswitch
in both 5 Patch and 10 Patch modes.
To enable the Bounce Back feature, follow these steps:
From the preset screen, press the Edit/Select knob once to enter the
1.
menu navigation system.
2.
Turn the Edit/Select knob until the Foot Controller menu is selected
and press the knob again.
3.
In the Foot Controller menu, select Bounce Back and press the Edit/
Select knob to turn this feature on or off.
Press the Back button to save this setting.
4.
Bounce Back only works within each active bank of presets, meaning you
cannot select preset 1 in the Presets 1-5 bank, change banks, select
preset 51 in the Presets 51-55 bank and then bounce back to preset 1.
NOTE: When Bounce Back is enabled, bypassing presets from the Control 2
is no longer available.
To use the Bounce Back feature, follow these steps:
1.
Select a preset using an available preset footswitch (for our example,
we'll use Footswitch 1 – Preset 1).
2.
Select another preset (for our example, Footswitch 4 – Preset 4).
3.
Press Footswitch 4 again. Preset 1 is loaded.
4.
Subsequent presses of numbered Footswitch 4 will alternately load
Preset 4 and Preset 1. Pressing any other preset footswitch will abandon
the bounce back between these two presets.
Control 2 Owner's Manual