Cisco TANDBERG Edge MXP Kurulum Sayfası - Sayfa 2
Konferans Sistemi Cisco TANDBERG Edge MXP için çevrimiçi göz atın veya pdf Kurulum Sayfası indirin. Cisco TANDBERG Edge MXP 2 sayfaları.
Sayfayı Yazdır
Wall mounting instructions
Equipment needed
1
Bracket with screw
(included).
The recommended
mounting is here:
Screwdriver to remove
the base and mount the
bracket (included).
Hose (sleeve) to
accommodate the
cables between the
codec and the monitor
and camera (included).
Suitable screws (at least
4×15) to mount bracket
4
on wall (not included).
Each screw must be
able to sustain at least
10 kg when bracket is
mounted.
Screwdriver to mount
bracket on wall (not
included).
CAUTION:
Use screws in
all four holes for
mounting. Do not
rely on the center
hole alone.
Mount the Edge MXP codec (with all cables connected) onto the bracket. Use the wall bracket screw to fasten the unit.
7
Mounting the codec to
the left of the monitor
CAUTION:
remove this screw. Using other screws may damage the codec's interior and will void the warranty.
78-19994-01 Edge MXP Installation Sheet, March 2011
© 2011 Cisco Systems, Inc. All rights reserved.
Decide where to mount the Edge MXP codec.
DO NOT MOUNT IT HERE!
Alternative
mounting
Put Edge MXP codec on its
Unscrew the base using the enclosed screwdriver.
5
back.
Alternative
mounting
Do never use other screws than the 20 mm screw already attached to the wall bracket. Do not
Remove the monitor.
2
Alternative
mounting
Alternative
mounting
Mount the bracket on the wall.
3
Recommended
Alt. 1
Connect the cables as illustrated overleaf.
6
LAN/Ethernet
PC/Laptop
Mount the monitor and camera back in place. Camera mounting instructions are
8
printed overleaf.
Edge MXP
Cable management
Alt. 2
Make sure there is space
for all cables when the
monitor is put back in
place. Also make sure that
the cable connections will
be well hidden behind the
monitor.
PrecisionHD
camera
Microphone
Monitor
Power supply