Cisco TelePresence Profile 52 Başlangıç Kılavuzu - Sayfa 11

Konferans Sistemi Cisco TelePresence Profile 52 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco TelePresence Profile 52 42 sayfaları. Telepresence ex, mx, quick set c20, codec c, sx20 quick set, profile series video systems

Sayfayı Yazdır

Cisco TelePresence Systems

GettinG started Guide

Table of contents

Introduction

Configuration tasks (continued)

Setting the IP parameters

(when not set by a provisioning system)

Your video conference system must be connected to

an IP network. Both IP version 4 (IPv4) and IP version 6

(IPv6) are supported. In both cases, the IP parameters

can be assigned automatically by the network, or you can

set everything manually.

Choose one of the following methods to set the IP

parameters:

Touch controller

Remote control and

on screen menu

Web interface

User interfaces

Setting the H.323 and SIP parameters

(when not set by a provisioning system)

To get online and ready to place and receive calls, your

system must be set up properly. Your system will use

either the H.323 protocol or the SIP protocol for video

calls.

Choose one of the following methods to set the H.323

and SIP parameters:

Touch controller

Remote control and

on screen menu

Web interface

Configuration

Appendices

Setting date and time

(when not set by a provisioning system)

When setting up your video conference system, you

should check that the date and time settings are correct.

Among other things this information is used to time stamp

messages transmitted to gatekeepers and other network

elements.

Choose on of the following methods to set the codec

password:

Touch controller

Remote control and

on screen menu

Web interface