Cisco TelePresence SpeakerTrack 60 Kurulum Kılavuzu - Sayfa 11
Konferans Sistemi Cisco TelePresence SpeakerTrack 60 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco TelePresence SpeakerTrack 60 19 sayfaları. Telepresence
Ayrıca Cisco TelePresence SpeakerTrack 60 için: Veri Sayfası (3 sayfalar), Kurulum Kılavuzu (14 sayfalar), Manuel (22 sayfalar), Kamera Kılavuzu (40 sayfalar), Kamera Kılavuzu (44 sayfalar)
Sayfayı Yazdır
Mounting the cables
Connect the cables to the connector panel on the base unit:
1.
Find the Ethernet cables (I, J) and the power cables (g, H) in the accessories box. Connect
the short cables to the connectors marked R (
marked L (
mounting.
2.
Connect the microphone cables coming from the microphone panel.
3.
Find the power adapter and the power cable (K) in the accessories box. Connect the power
cable to the base unit.
4.
Connect an Ethernet cable (not included) to the Ethernet port on the base unit. Connect
the other end directly to the codec. If you do not have any free Ethernet port on the codec
(typically if a Touch device is connected) you will need a network switch. Connect the
switch to the Ethernet port on the codec, and connect the Touch device and SpeakerTrack
60 to the switch. We recommend using a Cisco switch.
Connect the short Ethernet and
1
power cables to the right camera,
and the long Ethernet and power
cables to the left camera.
Connect the
3
power cable.
Rear view
78-100223-02C0 | MARCH 2015.
Copyright © 2015 Cisco Systems, Inc. All rights reserved.
). Lead them through the open slot to make them available for camera
) and the long cables to the connectors
Connect the microphone
2
cables that comes from the
microphone panel.
Connect the Ethernet
4
cable (not included)
directly to the codec
(Eth2/Eth3).