Argo FCIBS9DC Kullanım Talimatları Kılavuzu - Sayfa 9
Klima Argo FCIBS9DC için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Argo FCIBS9DC 15 sayfaları. Split air conditioner system
oPERAtIon WIthoUt thE REMotE
ContRoL UnIt
If you have lost the remote control unit or it has troubles,
follow the steps below.
1. WhEn thE AIR ConDItIonER IS StoPPED
If you want to turn on the air conditioner push the
OPERATION selector with a pen to select the desired
mode (COOL or HEAT).
notE
the air conditioner will start in hIGh fan speed.
the temperature setting is 25°C for cooling mode and
21°C for heating mode.
2. WhEn thE AIR ConDItIonER IS RUnnInG
If you want to turn off the air conditioner push the
OPERATION selector with a pen until the OPERATION
lamp is turned off.
notE
Power failure during operation.
In the event of power failure, the unit will stop. When the
power is resumed, the unit will restart automatically after
3 minutes.
CARE AnD CLEAnInG
WARnInG
Maintenance operations must be carried out by specially
l
trained personnel.
For safety, be sure to turn the air conditioner off and also
l
to disconnect the power before cleaning.
Do not pour water on the indoor unit to clean it. This will
l
damage the internal components and cause an electric
shock hazard.
CASInG AnD GRILLE (InDooR UnIt)
Clean the casing and grille of the indoor unit with a vacuum
cleaner brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with
a mild liquid detergent.
When cleaning the grille, be careful not to force the vanes
out of place.
CAUtIon
Never use solvents, or harsh chemicals when cleaning
l
the indoor unit. Do not wipe the plastic casing using very
hot water.
Some metal edges and the vanes are sharp and may
l
cause injury if handled improperly; be especially careful
when you clean these parts.
The internal coil and other components of the outdoor
l
unit must be cleaned every year. Consult your dealer or
service centre.
OPERATION
selector
AIR FILtER
The air filter should be cleaned at least once every
six months or more frequently; it depends on the real
operation conditions.
1.
2.
FILtER CLEAnInG
Use a vacuum cleaner to remove light dust. If there is
sticky dust on the filter, wash the filter in lukewarm,
soapy water, rinse it in clean water, and dry it.
9
EG