Cisco TelePresence SX10 Kullanıcı Kılavuzu - Sayfa 12

Konferans Sistemi Cisco TelePresence SX10 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Cisco TelePresence SX10 38 sayfaları. In-room control on touch 10
Ayrıca Cisco TelePresence SX10 için: Kurulum Kılavuzu (8 sayfalar), Kullanıcı Kılavuzu (26 sayfalar), Hızlı Kılavuz (2 sayfalar), Kullanıcı Kılavuzu (34 sayfalar), Kullanıcı Kılavuzu (29 sayfalar), Ön Kullanım Kılavuzu (9 sayfalar), Kurulum Kılavuzu (8 sayfalar), Kullanıcı Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (37 sayfalar), Manuel (45 sayfalar), Manuel (45 sayfalar), Kurulum Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (34 sayfalar), Kullanıcı Kılavuzu (5 sayfalar), Kullanıcı Kılavuzu (38 sayfalar), Kullanıcı Kılavuzu (38 sayfalar), Başlangıç Kılavuzu (46 sayfalar), Hızlı Kılavuz (2 sayfalar)

Video Calls

Place Call Using Name, Number or IP-Address

Make sure Call is selected (the leftmost

icon along the bottom of the screen) and

press OK on the remote control or press

the green Call button on the remote control.

To use the virtual keyboard, navigate down

to and about the keyboard and select

characters. Press OK to select a character.

D1509712 User Guide

Cisco TelePresence SX10, SX20

Produced: June 2017 for CE9.1

Use the Cursor keys to navigate to the

Search or Dial field at the top of the menu.

Press OK.

Then press the green Call button to place

the call.

To enter numbers just press the

corresponding keys on the remote control.

Press the red End Call button on the

remote control, or use the Cursor keys to

select End and then press OK to terminate

the call.

You may call someone who is not

listed in your list of contacts by

keying in their name, address or

number using the virtual keyboard.

Anyone you have previously called

will appear in the Recents list and

you may then add any of them

to your list of Favorites. This is

described in the section Contacts.

Call Using Video Address

The procedure when using an IP

type video address to call someone

is similar. Just key in the address

and use

(the asterisk button

in the lower left corner on the

remote control) as separator. The

system will interpret this as a valid

IP address separator so that the

video address appears as correctly

entered.