Sony BVP-900 Series Kullanım Kılavuzu - Sayfa 13

Video Kamera Sony BVP-900 Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Sony BVP-900 Series 48 sayfaları. Color video camera

Sayfayı Yazdır

@¡ MIX VF (mix viewfinder) switch

Selects the picture in the viewfinder when the RET 1

or RET button is depressed.

ON: When the RET 1 or RET button is depressed, the

mixed picture of the camera output signal and the

return video signal (return video 1 or the return

video signal selected at the RETURN SELECT

knob) can be monitored on the viewfinder screen.

The mixing ratio can be adjusted with the control

on the internal board of the CCU-700A/700AP.

For details, refer to the System Manual.

OFF: Only the return video 1 or the return video

signal selected at the RETURN SELECT knob can

be monitored when the RET 1 or RET button is

pressed.

@™ UP TALLY switch

Selects whether to make the external tally lamp, up

tally lamp or front tally lamp on the viewfinder lit

when a red tally signal is supplied to this camera

system.

ON: The tally lamps light.

OFF: The tally lamps do not light.

You can adjust the brightness of the up tally lamps on

the BVP-900/900P and the viewfinder.

For details, refer to the System Manual.

@£ SAFETY ZONE switch

ON: A box (safety zone) indicating 90% of the picture

appears on the viewfinder screen.

OFF: A safety zone does not appear on the viewfinder

screen.

You can change the size of the safety zone to 80%

with a switch on the BVP-900/900P.

For details, refer to the System Manual.

@¢ CENTER MARKER switch

ON: A white cross (center marker) indicating the

center of the viewfinder screen appears on the

viewfinder screen.

OFF: A center marker does not appear on the

viewfinder screen.

You can adjust the position of the center marker to the

center of the lens to be used. The adjusted position can

be stored in a lens file.

For details, refer to the System Manual.

@∞ CC (color temperature conversion) filter control

Selects a filter suitable for the lighting conditions when

the FILTER LOCAL button is lit.

Position

Filter

Cross filter

3200K (Clear)

4300K

6300K

8000K

@§ Spare switch

@¶ ND filter control

Selects the ND filter when the FILTER LOCAL button

is lit.

Position

Filter

Clear

@• FILTER LOCAL (filter local control) button

Press and light up this button to enable switching the

CC and ND filters using the CC and ND filter controls.

Press this button again so it goes out to return filter

control to the master setup unit or remote control

panel.

@ª VF (viewfinder) connector (D-sub 25-pin)

Connect to the camera connector on a viewfinder.

#º Memo clip

#¡ MIC (intercom microphone) ON/OFF switch

Turns the headset microphone on or off.

#™ INTERCOM PROD/ENG (intercom producer/

engineer line) switch

Selects the destination of the intercom 1 or 2 signals

between the producer line and engineer line.

PROD: Goes to the producer line.

ENG: Goes to the engineer line.

11 (E)