Sony CCU-790P Kullanım Kılavuzu - Sayfa 8

Video Kamera Sony CCU-790P için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Sony CCU-790P 18 sayfaları. Camera control unit
Ayrıca Sony CCU-790P için: Broşür ve Teknik Özellikler (14 sayfalar)

Sayfayı Yazdır

(on MSU-900) to select the signal output from the WF

connector. When the output signal is changed on the RCP-

750/751 or the RM-B750, the picture on the picture monior

also changes.

e REMOTE (remote control) connector (8-pin)

Connects to the MSU-900/950 Master Setup Unit, RCP-

750/751/920/921 Series Remote Control Panel or RM-

B750 Remote Control Unit with an optional CCA-5-xx

connecting cable to transmit/receive control signals.

f ETHERNET connector

Through this connector, the Ethernet system can be built

with the devices conforming to 700 Protocol Over TCP/IP,

such as the MSU-900/950 or RCP-920/921

to build the Ethernet system, the internal switch setting and

the network-related settings must be made.

For details, consult your Sony service personnel.

1) Power must be supplied to the RCP-920/921 through the Ethernet

connection.

CAUTION

For safety, do not connect the connector for peripheral

device wiring that might have excessive voltage to this

port. Follow the instructions for this port.

g INTERCOM/TALLY/PGM (program audio)

connector (D-sub, 25-pin)

Inputs/outputs intercom, tally, or program audio signals.

Connects to an intercom, tally, or program audio connector

of an intercom system.

h MIC REMOTE (microphone remote control)

connector (D-sub, 15-pin)

Connects to an external control unit such as an audio

mixer. With the connected unit, you can set the

microphone input level of the video camera to –60, –50,

–40, –30, or –20 dB.

i WF MODE (waveform monitor mode) connector

(4-pin)

Connects to the corresponding connector on a waveform

monitor to allow the sequential monitoring of signals.

j AC IN (AC power input) connector

Connects to an AC power source using the supplied AC

power cord. Secure the power cord to the CCU-790/790P

using the supplied plug holder.

Function and Location of Parts and Controls

k SDI (serial digital interface) OUTPUT connectors

, etc. In order

A SDI-4/5/6 connectors (BNC type)

When the VBS/SDI-1 connector is set to output the SDI

signal, the same signal as that to be output from the VBS/

SDI-1 connector is output from these connectors.

B SPARE connector (BNC type)

Not used.

A SDI-4/5/6 connectors

B SPARE connector