Cisco TelePresence System Codec C90 Manuel - Sayfa 24

Konferans Sistemi Cisco TelePresence System Codec C90 için çevrimiçi göz atın veya pdf Manuel indirin. Cisco TelePresence System Codec C90 25 sayfaları. Telepresence system
Ayrıca Cisco TelePresence System Codec C90 için: Kullanıcı Kılavuzu (44 sayfalar), Başlangıç Kılavuzu (42 sayfalar), Sorun Giderme Kılavuzu (37 sayfalar), Kurulum Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (48 sayfalar), Başlangıç Kılavuzu (46 sayfalar)

Sayfayı Yazdır
Cisco TelePresence System Codec C90 Manuel
Cisco TelePresence System Codec C90
Contents

GPIO and other connectors

GPIO
1 × GPIO (General Purpose Input/Output)
6 pins Phoenix plug, having 4 ports for On/Off control, GND
and +12V.
You can configure input/output integrations by using pre–
defined behavior. Exposure of states and commands for
external control requires external programming.
For information about the API commands, see the API Guide
for the codec, go to:
http://www.cisco.com/go/telepresence/
docs
Usage information
•
A contact closure between the GND and a GPIO port pin is
detected as a low input signal.
•
When used for voltage inputs, the GPIO port detects it as:
•
Low signal for voltages 0 - 1 VDC
•
High signal for voltages 2 - 12 VDC
•
When used for outputs, the GPIO port acts as a switch
to GND, and is rated for 500mA @ 48V DC. The +12V pin
provides +12 VDC, and is capable of sourcing up to 500mA.
•
The GND connector is a common ground for all pins in the
GPIO port.
USB
1 × USB Host
1 × USB Device
For future use.
T Link
2 × T Link, RJ45 connector.
The cable for T Link out must be shielded.
For future use.
D14644.03 Codec C90 Physical Interface Guide TC4.1, February 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
Introduction
Connecting to the codec
GPIO
GPIO pin-out
+12V
4
3
GND
The physical interface
The physical interface
USB
(for future use)
2
1
24
Physical interface guide
Contact us
T Link
(for future use)
www.cisco.com