Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor Donanım Kurulum Kılavuzu - Sayfa 14
Ağ Donanımı Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor 36 sayfaları. User guide
Sayfayı YazdırGrounding the Shelf
Installing the Fiber Routing Drawer
To install the fiber routing drawer, follow these steps:
Hold the drawer with both hands and position the drawer in the rack beneath the chassis.
Step 1
(See
Align the mounting holes on the bracket with the mounting holes in the equipment rack.
Step 2
Install the 12-24 or 10-32 screws through the elongated holes in the brackets and into the threaded holes
Step 3
in the mounting post. Repeat this step for the other side.
Grounding the Shelf
Two system (earth) grounding holes are provided under the power supplies at the bottom right of the
shelf.
Shelf Grounding Guidelines
To make an adequate grounding connection, you need the following parts and tools:
•
•
•
•
•
•
The grounding lug and M4 screws are included in your accessory kit that ships with the system.
Note
Shelf Grounding Procedures
This section describes how to connect the Cisco ONS 15530 to earth ground. You must complete this
procedure before connecting system power or powering up your shelf.
Cisco ONS 15530 Hardware Installation Guide
2-14
Figure
2-9.)
Grounding lug.
Two M4 (metric) hex-head screws with locking washers.
One grounding wire (6 AWG recommended).
Number 2 Philips head screwdriver.
Crimping tool. This tool must be large enough to accommodate the girth of the grounding lug when
you crimp the grounding cable into the lug.
Wire-stripping tool.
Chapter 2
Installing the Cisco ONS 15530
OL-7706-01