Argo SDIBS9DC Kurulum Talimatları Kılavuzu - Sayfa 16

Klima Argo SDIBS9DC için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Argo SDIBS9DC 19 sayfaları. Split air conditioner system
Ayrıca Argo SDIBS9DC için: Kullanım Talimatları Kılavuzu (15 sayfalar), Kullanım Talimatları Kılavuzu (17 sayfalar)

Sayfayı Yazdır

16 - MATCH BETWEEN REMOTE CONTROLLER AND INDOOR UNIT

(TRANSMISSION CHANNEL)

The remote control can be addressed to use up to 4 different units installed in the same room.

You can get unified control by using a single remote control for all units or each remote control can be addressed to its

own unit, in order to control separately temperature, timer and all other functions.

PCB SETTING

• Disconnect the unit power supply and wait at least 60 seconds, making sure that all the lamps go off.

• Remove the front panel to access the pcb.

• Set SW1 as shown in the table.

• Close the front panel.

• Reconnect the unit power supply.

REMOTE CONTROLLER SETTING

• Press the button

• Press the arrow

• Press the button

• Press the arrow

• Confirm with the button

• Press

to exit the menu.

CHANNEL

FACTORY STATE

for a few seconds.

until you visualize 08.

again for a few seconds: the number 0 (factory setting) at the bottom starts flashing.

to set 0, 1, 2 or 3.

REMOTE CONTROL UNIT

SW1: 1=OFF 2=OFF

SW1: 1=ON 2=OFF

SW1: 1=OFF 2=ON

SW1: 1=ON 2=ON

UNIT PCB