Cisco 3800 Series Kullanıcı Kılavuzu - Sayfa 2
Ağ Donanımı Cisco 3800 Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Cisco 3800 Series 7 sayfaları. Password recovery procedure
Ayrıca Cisco 3800 Series için: Veri Sayfası (8 sayfalar), Uygulama Notu (41 sayfalar), Sorun Giderme Kılavuzu (15 sayfalar), Veri Sayfası (20 sayfalar), Hızlı Başlangıç Kılavuzu (40 sayfalar), Yapılandırma (32 sayfalar)
Sayfayı Yazdır
Step−by−Step Procedure
Follow these steps in order to recover your password:
1.
Attach a terminal or PC with terminal emulation to the console port of the router.
Use these terminal settings:
♦
9600 baud rate
♦
No parity
♦
8 data bits
♦
1 stop bit
♦
No flow control
Refer to these documents for information on how to cable and connect a terminal to the console port
or the AUX port:
♦
Cabling Guide for Console and AUX Ports
♦
Connecting a Terminal to the Console Port on Catalyst Switches
♦
Connect a Terminal to Catalyst 2948G−L3, 4908G−L3, and 4840G Series Switches
2.
If you can access the router, type show version at the prompt, and record the configuration register
setting. See Example of Password Recovery Procedure in order to view the output of a show version
command
Note: The configuration register is usually set to 0x2102 or 0x102. If you can no longer access the
router (because of a lost login or TACACS password), you can safely assume that your configuration
register is set to 0x2102.
3.
Use the power switch in order to turn off the router, and then turn the router back on.
Important Notes:
♦
In order to simulate this step on a Cisco 6400, pull out and then plug in the Node Route
Processor (NRP) or Node Switch Processor (NSP) card.
♦
In order to simulate this step on a Cisco 6x00 with NI−2, pull out and then plug in the NI−2
card.
4.
Press Break on the terminal keyboard within 60 seconds of power up in order to put the router into
ROMMON.
If the break sequence does not work, refer to Standard Break Key Sequence Combinations During
Password Recovery for other key combinations.
5.
Type confreg 0x2142 at the rommon 1> prompt in order to boot from Flash.
This step bypasses the startup configuration where the passwords are stored.
6.
Type reset at the rommon 2> prompt.
The router reboots, but ignores the saved configuration.
7.
Type no after each setup question, or press Ctrl−C in order to skip the initial setup procedure.
8.
Type enable at the Router> prompt.
You are in enable mode and should see the Router# prompt.
9.
Type configure memory or copy startup−config running−config in order to copy the nonvolatile
RAM (NVRAM) into memory.
Important: Do not type copy running−config startup−config or write. These commands erase your