Cisco 6015 Montaj ve Değiştirme Notları - Sayfa 13
Ağ Donanımı Cisco 6015 için çevrimiçi göz atın veya pdf Montaj ve Değiştirme Notları indirin. Cisco 6015 18 sayfaları. Dsl interface module fru
Ayrıca Cisco 6015 için: Hızlı Referans Kılavuzu (38 sayfalar)
Sayfayı Yazdır
Verify that the circuit breaker on the DC PEM is set to the OFF (0) position.
Step 2
Horizontally align the module edges with the module guides at the right and left of the slot in the
Step 3
Cisco 6015.
Figure 3
Figure 3
FA N 1
FA N 2
1
2
3
Hold the extraction handle on the front of the module and gently apply pressure while carefully pushing
Step 4
the module into the slot.
Step 5
Push on the faceplate of the module to fully seat the module.
Use a flat-head or Phillips-head screwdriver to attach the four screws to the Cisco 6015 chassis.
Step 6
Connect the DSL interface module to the POTS splitter (Cisco 6015 with a POTS splitter configuration)
Step 7
or MDF (Cisco 6015 without a POTS splitter configuration).
Use the cables that are described in the
DSL interface module to the POTS splitter or MDF. For cabling procedures for each POTS splitter, refer
to the appropriate vendor documentation.
Note
OL-2186-01
shows the DSL interface module installation.
DSL Interface Module Installation
4
5
6
If unshielded cable is used for FCC Class A or EN55022 Class A compliance, the cables will
need to be looped through ferrites.
Removing and Installing the DSL Interface Module
D S 3 + T1
I/O - 60
2
15
3
4
6
7
8
D C P E M
- 60 15
P W R
"Part and Tool Requirements" section on page 4
Installing the DSL Interface Module
5
TX
R X
48 /6 0V
S A
to connect the
13