Cisco 7507 Hızlı Başlangıç Kılavuzu - Sayfa 23

Ağ Donanımı Cisco 7507 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco 7507 44 sayfaları. Air filter and chassis blower replacement
Ayrıca Cisco 7507 için: Kurulum Talimatları Kılavuzu (39 sayfalar), Veri Sayfası (11 sayfalar), Değiştirme Talimatları Kılavuzu (21 sayfalar)

Sayfayı Yazdır

Start and Conﬁgure the System

Conﬁgure an Ethernet Interface

Step 1

To conﬁgure your system for an Ethernet

LAN, respond to the prompts as follows,

using your own IP address and subnet

mask information:

Configuring interface parameters:

Configuring interface Ethernet0/0:

Is this interface in use? [no]: yes

Configure IP on this interface? [no]: yes

IP address for this interface: 1.1.1.10

Number of bits in subnet field [0]:

Class A network is 1.0.0.0, 0 subnet bits;

mask is 255.0.0.0

Step 2

Enter yes to enable IPX on this interface,

using the IPX network number:

Configure IPX on this interface? [no]: yes

IPX network number [2]:

Step 3

Enter yes to enable AppleTalk on this

interface, to conﬁgure for extended

AppleTalk networks, and then enter the

cable range number. Enter the zone name

and any other additional zones that will

be associated with your local zone:

Configure AppleTalk on this interface? [no]:

yes

Extended AppleTalk network? [no]: yes

AppleTalk starting cable range [0]:

Step 4

At the # prompt, enter the copy

running-conﬁg startup-conﬁg command

to save the conﬁguration to NVRAM as

follows:

Hostname# copy running-config startup-config

Conﬁgure a Synchronous Serial

Interface

Step 1

Enter yes to conﬁgure serial port 0:

Configuring interface Serial1/0:

Is this interface in use? [no]: yes

Step 2

Determine which protocols you want to

allow on the synchronous serial interface

and enter the appropriate responses:

Configure IP unnumbered on this interface?

[no]:

IP address for this interface: 1.1.1.20