Cisco Aironet 1430 Series Başlangıç Kılavuzu - Sayfa 7

Ağ Donanımı Cisco Aironet 1430 Series için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco Aironet 1430 Series 48 sayfaları. Wireless bridge

Sayfayı Yazdır

Configuring the Bridge for the First Time

This chapter describes how to configure basic settings on your bridge for the first time. The contents

of this chapter are similar to the instructions in the quick start guide that shipped with your bridge.

You can configure all the settings described in this chapter using the command-line interface (CLI), but

it might be simplest to browse to the bridge's web-browser interface to complete the initial

configuration and then use the CLI to enter additional settings for a more detailed configuration.

This chapter contains these sections:

• Before You Start, page 7

• Obtaining and Assigning an IP Address, page 8

• Connecting to the Bridge Locally, page 9

• Assigning Basic Settings, page 10

• What To Do Next, page 14

• Assigning an IP Address Using the CLI, page 15

• Using a Telnet Session to Access the CLI, page 15

Before You Start

Before you install the bridge, make sure you are using a computer connected to the same network as

the bridge, and obtain the following information:

• From your network system administrator:

A system name

The case-sensitive wireless service set identifier (SSID) for your radio network

If not connected to a DHCP server, a unique IP address for your bridge (such as

172.17.255.115)

If the bridge is not on the same subnet as your PC, a default gateway address and subnet mask

A Simple Network Management Protocol (SNMP) community name and the SNMP file

attribute (if SNMP is in use)

Resetting the Bridge to Default Settings

If you need to start over during the initial setup process, follow these steps to reset the bridge to factory

default settings using the power injector's Mode button:

Step 1

Disconnect the power jack from the power injector.

THIRD FCC DRAFT (CISCO CONFIDENTIAL)