Sony PMW-300 Başlarken - Sayfa 2

Dijital Kamera Sony PMW-300 için çevrimiçi göz atın veya pdf Başlarken indirin. Sony PMW-300 2 sayfaları.

Sayfayı Yazdır
Performing the Upgrade
Note
Do not do any of the following while performing the
upgrade. Doing so could interrupt the upgrade process, and
cause malfunctions.
• Eject or insert an SxS memory card
• Turn the power off
For details on using each camcorder, refer to the
Operating Instructions for the camcorder.
1
Insert the SxS memory card containing the update data
into the camcorder.
Note
Do not insert another SxS memory card in the other
slot.
2
To upgrade the PMW-100/200/150/160/300:
Select "Version Up" from the OTHERS menu,
and then select "Execute".
Note
Do not rotate the camcorder's LCD monitor
toward the lens during the upgrade process.
(Video reversing is disabled during the upgrade
process.)
The following message appears: "Connect DC Power
to DC IN Upgrade Version?"
3
Select "Execute".
The message "Searching Package File" appears, and
the camcorder starts searching for the update data.
When the update data is found, the message "Version
VX.XX > VY.YY Upgrade" appears (X.XX: current
version number, Y.YY: latest version number).
If the update data is not found:
The message "Version Upgrade No File" appears.
The following are the possible causes.
• The update data is not saved to the root directory of
the SxS memory card.
• The update data for a different model is saved.
• The data could not be decoded correctly.
• The header information is incorrect.
Save the correct update data to an SxS memory card,
and restart the upgrade from step 1.
4
Select "Execute".
The upgrade begins.
There are three phases to the upgrade, labeled "Phase
1" to "Phase 3". Below are shown the messages
displayed during each phase, and the approximate time
they will take.
Message
Version Upgrade Phase1
Executing... xxxx Secs
Elapsed
Version Upgrade Phase2
Executing... xxxx Secs
Elapsed
Version Upgrade Phase3
Executing... xxxx Secs
Elapsed
Note
During switchover between completion of Phase 1 to
2, and the start of Phase 2 to 3, no message appears,
although the process is still running. Do not turn off
the power.
When the upgrade is complete, the following message
appears: "Version Upgrade OK: Turn Power Off".
If the upgrade was interrupted:
If there was an error in the update data, the following
message appears: "Version Upgrade NG: Cannot
Read. Power Off". Restart the camcorder, save the
correct update data to an SxS memory card, and then
restart the upgrade from step 1.
If the upgrade failed:
The message "Version Upgrade Error!!" appears. Re-
check the upgrade procedure, and restart the upgrade
from step 1.
If the upgrade still does not execute correctly, then
there may be a malfunction in the camcorder. Contact
your dealer or a Sony service representative.
5
Restart the camcorder.
6
Make sure that the version is now the latest (see
"Checking the Current Version").
If the version is not the latest:
Re-check the upgrade procedure, and restart the
upgrade from step 1.
Approximate time
PMW-100
About 7
minutes
PMW-200
About 5
minutes
PMW-150/160
About 4
minutes
PMW-300
About 4
minutes
PMW-100
About 6
minutes
PMW-200
About 3
minutes
PMW-150/160
About 4
minutes
PMW-300
About 14
minutes
PMW-100
About 15
minutes
PMW-200
About 11
minutes
PMW-150/160
About 11
minutes
PMW-300
About 10
minutes