Sony XC-ST51 Teknik Kılavuz - Sayfa 7

Dijital Kamera Sony XC-ST51 için çevrimiçi göz atın veya pdf Teknik Kılavuz indirin. Sony XC-ST51 30 sayfaları. Black-and-white video camera module
Ayrıca Sony XC-ST51 için: Manuel (4 sayfalar)

Sayfayı Yazdır

Rear Panel

1 HD/VD signal input/output switch

2 VIDEO OUT (Video signal output)

connector (BNC)

3 γ compensation ON/OFF switch

4 GAIN switch

5 Manual gain control

1 HD/VD signal input/output switch

Set the switch to INT to output HD/VD signals from

the camera module.

Set the switch to EXT to input HD/VD signals from an

external unit. (Factory setting: EXT)

2 VIDEO OUT (Video signal output) connector

(BNC)

You can use this connector for video signal output

from the camera module.

3 γ compensation ON/OFF switch

Turn on this switch for γ compensation. (Factory

setting: OFF)

4 GAIN switch

This switch selects AGC (A), fixed gain (F), or manual

gain control (M). (Factory setting: F)

5 Manual gain control

Adjust the gain using this control. GAIN switch 4

must have been set to M (Manual).

6 Shutter speed/Mode setting DIP switch

1 Shutter speed (bits 1 – 4)

Set an appropriate shutter speed. (Factory

setting: Shutter off)

2 Potential accumulation mode (bit 5)

Factory setting: FRAME

XC-ST51/ST51CE

XC-ST50/ST50CE

XC-ST30/ST30CE

9 DC IN/SYNC (DC power input/sync

signal I/O) connector (12-pin)

8 TRIG polarity switch

7 75 Ω termination switch

6 Shutter speed/Mode

setting DIP switch

3 Restart reset/External trigger shutter mode

switch (bits 6 – 8)

Factory setting: Normal

Notes

• Do not use any other settings for Restart reset/

External trigger shutter mode except those

shown in page 12. Using other settings may

cause the camera to malfunction.

• If you set the External trigger shutter mode, set

0 in bits 1 – 4.

7 75 Ω termination switch

Turn off if you do not terminate. (Factory setting: ON)

8 TRIG polarity switch

Select + or – according to the trigger pulse input from

an external unit. (Factory setting: +)

9 DC IN/SYNC (DC power input/sync signal I/O)

connector (12-pin)

Connect a CCXC-12P05N camera cable to this

connector the +12 V DC power supply and the video

signal output from the camera module. When a sync

signal generator is connected to this connector, the

camera module is synchronized with the external sync

signals.

Overview