Cisco APP-LMM Kurulum ve Yükseltme - Sayfa 19

Ağ Donanımı Cisco APP-LMM için çevrimiçi göz atın veya pdf Kurulum ve Yükseltme indirin. Cisco APP-LMM 32 sayfaları. Fddi card and appliques

Step 4

Step 5

Installing a Short Ground Strap

The ground strap, which is included with all appliques, grounds the applique to the chassis to prevent

EMI noise on your network interface. The applique card cage containing the FDDI appliques should

already be installed in the chassis and secured with ﬁve screws. Refer to Figure 12 while you install

the short ground strap.

Figure 12

Step 1

Step 2

Step 3

Step 4

Attach the appropriate label (FDDI 0, FDDI 1, and so forth) to the lower part of the

applique faceplate; the label will be clearly visible in this position.

Decide if your installation requires a short or long ground strap. Use a short ground strap

when you install the applique next to a blank connector plate (see Figure 12) or next to an

applique that does not contain a hole for the long ground strap screw. Use a long ground

strap when you install the applique next to an applique that contains a hole for the long

ground strap, for example, another FDDI applique (see Figure 13).

Short Ground Strap Installation

Ground strap

Remove the Phillips screw from the top center of each applique.

Position the ground strap so that it straddles the applique and rear panel of the chassis.

Align the holes in the ground strap with those on the rear panel and the applique.

Secure the ground strap with the two Phillips screws.

Connect ground straps to other appliques as necessary, and proceed to the section,

"Connecting Internal and External Cables" on page 20.

Installing and Upgrading the CSC-C2FCIT FDDI Card and Appliques

RING A

RING B

Installing Cards and Appliques