Sony MHC-GN660 Kullanım Talimatları Kılavuzu - Sayfa 39

Stereo sistemi Sony MHC-GN660 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Sony MHC-GN660 48 sayfaları. Sony mhc-gn660 stereo system: user guide
Ayrıca Sony MHC-GN660 için: Kullanım Talimatları Kılavuzu (48 sayfalar)

Sony MHC-GN660 Kullanım Talimatları Kılavuzu
The tape does not record.
• No tape is loaded
Load a tape.
• The tab has been removed
fwm the tape Cover
the bzoken tab with adhesive
tape (page 41)
• The tape has wotmd to the end.
The Deck A does not playback
reverse
side.
(MHC-GX9000/GN660
only)
• The Deck A only playback
flont side of the tape.
This is not a malflmction.
If the
system
still
does
not
operate
properly
after
performing
the
above
measures
or other
troubles
does
not
described
above
occur,
reset
the
system
as
follows:
Use buttons
on the system for the operation.
1
Unplug the power cord.
2 Plug the power cord back in.
3 Press I/(_ to turn on the system.
4 Press II, ENTER and I/5
at the same time.
The system is reset to the fi_ctory settings. All
the setting are cleared. You should set the
settings you made, such as the preset stations,
clock and timer.
One of the following
messages
may appear or
flash in the display dnring operation.
CD/MP3
NO STEP
You have clealed
all the tracks you programmed
OVER
You have leached
the end of the disc while tmmng
and holding
_
_
clockwise
(or pressing
on the remote)
during playback
or pause playback.
No Disc
There is no disc in the system.
Push STOP!
You plessed
PLAY
MODE
duling playback.
Step Full!
You tried to program
more than 25 steps
Reading
The system
is leading
intbrmation
of the disc. Some
buttons
are not available.
Tape
No Tab
You cannot zecord the tape because the tab has been
removed
from the tape
No Tape
There is no tape in the tape deck
Timer
OFF TIME NG!
The on time and oft" time of Pla t, Time! o! Time!
Recording
is same
SET CLOCK!
You pressed CLOCK/TIMER
SELECT
before the
clock is set
SET TIMER!
You plessed
CLOCK,'TIMER
SELECT before Pla t,
Timer or Timer
Recording
is set.
PUSH
SELECT!
You tried to set the clock o! lima
during time!
operation
r-
Ut
0
o
5'
I,Q