ACU-RITE 745604-NN Yazılım Güncellemesi - Sayfa 6

Müzik Mikseri ACU-RITE 745604-NN için çevrimiçi göz atın veya pdf Yazılım Güncellemesi indirin. ACU-RITE 745604-NN 6 sayfaları.
Ayrıca ACU-RITE 745604-NN için: Yazılım Güncellemesi (6 sayfalar), Yazılım Güncellemesi (5 sayfalar), Yazılım Güncellemesi (6 sayfalar), Yazılım Güncellemesi (6 sayfalar), Yazılım Güncellemesi (5 sayfalar), Yazılım Güncellemesi (6 sayfalar), Yazılım Güncellemesi (7 sayfalar), Yazılım Güncellemesi (3 sayfalar), Yazılım Güncellemesi (5 sayfalar), Yazılım Güncellemesi (3 sayfalar), Yazılım Güncellemesi (3 sayfalar)



All input dialogs now correctly disable all softkeys while they are open, such that the

user must complete the task before attempting other actions.



In the View Setup dialog, pressing the Reset Graphics soft key was resetting too many

settings; only Pan/Rotate/Zoom should be reset.



In Installation Setup, the Max Servo Speed setting would only allow entering a lower

value than the currently active max speed. It now properly allows any speed between 10

and 100 inch per minute, regardless of what max speed is currently active in the system.



Fixed an issue where creating a directory in the USB drive failed sometimes.



Fixed an issue where the "Redraw" button and/or decimal key would not properly cancel

and re-start a new simulation if a simulation was already in progress.



More (F8) softkey was missing when focus on the pocket/contour parameter in cycles

that support the pocket/contour parameter.



Fixed an issue where a "Module missing" error appears sometimes when a simulation is

cancelled.



Corrected an issue with AMI systems in which the axes lubrication output would not

function properly in R5+ versions.



Fixed an issue where the Cancel button does not respond while copying the files

sometimes.



Scale factor not applied to DRO display values on power-up. Changing the scale factor

from Job Setup corrects the display values. The datum form and program execution are

not affected by this problem.



Fixed an issue where Set Spindle Speed gives an unnecessary prompt to press the GO

key.

If any issues are encountered, please contact your service representative for assistance or

contact technical support at

if you have any questions.