Sony MHC-GX30 Kullanım Talimatları Kılavuzu - Sayfa 26
Stereo sistemi Sony MHC-GX30 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Sony MHC-GX30 31 sayfaları. Sony mhc-gx20 stereo system: system manual
Ayrıca Sony MHC-GX30 için: Kullanım Talimatları Kılavuzu (32 sayfalar), (İngilizce) Eğitim Kılavuzu (32 sayfalar)
Sayfayı Yazdır
Problems and remedies (continued)
CD Player
The CD tray does not close.
• The CD is not placed properly.
The CO will not play.
• The CD is not lying flat in the disc tray.
• The CD is dirty.
• The CD is loaded label side down.
• There is moislure
on the CD.
Play does not start from the first track.
• The player is in program
or shu file mode. Press
PLAY MODE
repeatedly
until "PGM" or
"SItUF"
disappears.
The disc tray does not open and "LOCKED"
appears.
• Contact
your Sony dealer or local authorized
Sony service
facilily.
Tape
Deck
The tape does not record.
• NO tape in the cassette
holder.
• The tabhas been removed
from the cassette
(see
"To save a tape permanently"
on page 27).
• The tape has reeled
to the end.
The tape does not record nor play or there is a
decrease
in sound level.
• The heads are dirty (see "Cleaning
the tape
heads" on page 28).
• The record/playback
heads
are magnetized
(see
"Demagnelizing
the tape heads"
on page 28).
The tape does not erase completely.
• The record/playback
heads
are magnetized
(see
"Demagnelizing
the tape heads"
on page 28).
There is excessive
wow or flutter, or the sound
drops out.
• The capstans
or pinch rollers arc dirty (see
"Cleaning the tape heads"
on page 28).
Noise increases
or the high frequencies
are
erased.
• The record/playback
heads
are magnetized
(see
"Demagnelizing
the tape heads"
on page 28).
Tuner
There is severe hum or noise ("TUNED"
or
"STEREO"
flashes in the display).
• Adjust the antenna.
• The signal strength
is too weak. Connect
the
external
antenna.
A stereo FM program cannot be received in
stereo.
• Press STEREO/MONO
on the remote
repealedly
until "MONO" disappears.
If other
troubles
not described
above
occur,
reset
the system
as follows:
1
Unplug the power cord.
2 Plug the power cord back in.
3 Press I, GROOVE, and I/(_ at the same
time.
4
Press Ig@ to turn on the system.
The system is reset it) the factory settings. All
the settings you made are cleared.
One of the fbllowing messages
may appear or
flash in the display during operation.
NO DISC
• There is no CD on the disc tray.
OVER
• You have reached
the end of the CD.
"PROTECT"
and "PUSH POWER"
appear
alternately.
• A strong signal was input. Press I/(_3 to turn off
the system, leave the system
mined off tbr a
while, then press
I/([) again to turn on the
system.
If"PROTECT"
and "PUSH POWER"
appear alternately
even at}er the system
is turned
on again, press I/(_
Io turn offthe
syslem
and
check the speaker
cord.
26 GB