Sony MHC-VX555 Kullanım Talimatları Kılavuzu - Sayfa 31

Stereo sistemi Sony MHC-VX555 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Sony MHC-VX555 36 sayfaları.

Sayfayı Yazdır

If color irregularity is observed...

Turn off the TV set once, then turn it on after 15 to 30

minutes.

If color irregularity is observed

again...

Place the speakers farther away from the TV set.

Troubleshooting

If you run into any problem using this unit, use

the following check list.

First, check that the power cord is connected

firmly and the speakers are connected correctly

and firmly.

Should any problem persist, consult your

nearest Sony dealer.

General

The display starts flashing as soon as you plug

in the power cord even though you haven't

turned on the power (demonstration mode).

Press DISPLAY when the power is turned off.

The demonstration mode appears automatically the

first time you plug in the power cord or if there is a

power outage.

The clock setting is canceled.

• The power cord is disconnected or a power

failure occurs. Redo "Setting the time" (on page

8). If you have set the timer, redo "Waking up to

music" (on page 27) and "Timer-recording radio

programs" (on page 21).

The radio presetting/timer setting is canceled.

• The power cord is disconnected or a power

failure occurs for longer than half a day. Redo

"Presetting radio stations" (on page 17).

There is no sound.

• Turn VOLUME clockwise.

• The headphones are connected.

• Insert only the stripped portion of the speaker

cord into the SPEAKER jack. Inserting the vinyl

portion of the speaker cord will obstruct the

speaker connections.

• The protective device on the amplifier has been

activated because of short circuit. ("PROTECT"

and "PUSH POWER" flash alternately.) Turn off

the unit, eliminate the short-circuit problem and

turn on the power again.

• There is no audio output during timer recording.

10ADD_MHC-VX777/VX555.p65 GB

There is severe hum or noise.

• A TV or VCR is placed too close to the stereo

system. Move the stereo system away from the

TV or VCR.

The sound from the connected source is

distorted.

• If "VIDEO" appears in the display when you

press MD (VIDEO), switch the display to "MD"

(see "Note: Connecting MD deck/VCR" on page

28).

"-- --:-- --" flashes in the display.

• A power interruption occurred. Set the clock and

timer settings again.

The timer does not function.

• Set the clock correctly.

DAILY 1 SET, DAILY 2 SET and REC SET do not

appear when you press the CLOCK/TIMER SET

button.

• Set the timer correctly.

• Set the clock.

The remote does not function.

• There is an obstacle between the remote and the

system.

• The remote is not pointing in the direction of the

system's sensor.

• The batteries have run down. Replace the

batteries.

There is acoustic feedback.

• Decrease the volume level.

• Move the microphone away form the speakers or

change the direction of the microphone.

The color irregularity on a TV screen persists.

• Turn off the TV set once, then turn it on after 15

to 30 minutes. If the color irregularity still

persists, place the speakers farther away from the

TV set.

"PROTECT"and "PUSH POWER" appear

alternately.

• A strong signal was input. Press ?/1 to turn off

the power, leave the system turned off for a

while, then press ?/1 again to turn on the power.

• Check the speaker cables in case "PROTECT"

and "PUSH POWER" appear alternately again

after you turn the system on.

MHC-VX777/VX555/VX555J 4-232-651-12 (1)

13/03/2001, 5:00 PM