devices that are on the home network.)"
(page 34) if the LINK indicator goes off,
flashes or lights up in red.
• This unit cannot play back audio content in
the following case.
-There is no server device.
-There is no audio content that can be
played back on the server.
Refer to "Home Network" (page 34) if the
problem does not apply to one of the following
cases.
During a PARTY
This unit cannot join a PARTY.
• Make sure the LINK indicator is lighting
up in green or amber. Refer to "The unit
cannot connect to the network. (The unit
cannot be found or recognized by other
devices that are on the home network.)"
(page 34) if the LINK indicator goes off,
flashes or lights up in red.
• Make sure of the status of other PARTY
guest. The unit cannot join a PARTY if
other PARTY devices have all left the
PARTY. Play back via another PARTY
device when you join the PARTY as a
PARTY guest.
If you want to start a PARTY as a PARTY
host, press and hold PARTY for two
seconds or more.
• Deactivate the multicast control of your
wireless LAN router/access point if it is
activated. Refer to the operating manual of
your wireless LAN router/access point for
details.
The unit takes a few minutes to connect
to the PARTY host.
• Check the status of the PARTY
STREAMING indicator. The PARTY has
already closed if the PARTY
STREAMING indicator goes off.
36GB
This unit is the PARTY host if the PARTY
STREAMING indicator lights up in green.
Play back the audio content.
Using this unit as a PARTY host
This unit cannot start a PARTY.
• Make sure the LINK indicator is lighting
up in green or amber. Refer to "The unit
cannot connect to the network. (The unit
cannot be found or recognized by other
devices that are on the home network.)"
(page 34) if the LINK indicator goes off,
flashes or lights up in red.
This unit cannot leave the PARTY.
• You cannot leave the PARTY while using
this unit as a PARTY host.
Another device cannot join the PARTY
that is being held on this unit.
• The number of PARTY guest exceeds the
maximum number when the PARTY
STREAMING indicator flashes green and
red alternately. Remove one of the PARTY
guest.
The NETWORK STANDBY indicator
flashes in amber.
• The system is in protect mode.
• Disconnect and reconnect the AC cord of
the unit, then turn the unit on again.
If the NETWORK STANDBY indicator
still flashes, consult your nearest Sony
dealer.
This unit does not work correctly.
• This unit is affected by static electricity,
etc. Set the power switch to OFF, and then
set it to ON again. Reset this unit if the unit
does not work correctly.
Sayfayı Yazdır