Cisco ASR 5000 Kurulum Kılavuzu - Sayfa 2
Ağ Donanımı Cisco ASR 5000 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco ASR 5000 33 sayfaları. Applying power and verifying the installation
Ayrıca Cisco ASR 5000 için: Kurulum Kılavuzu (18 sayfalar), Kurulum Prosedürü (8 sayfalar), Kurulum Kılavuzu (37 sayfalar)
Sayfayı Yazdır
Using the CLI to View Status LEDs
Using the CLI to View Status LEDs
The status of application and line card LEDs can be viewed through the CLI by entering the show leds all
command in Exec mode.
[local]
The following displays a sample of this command's output.
Slot 01: Run/Fail: Green
Slot 08: Run/Fail: Green
Slot 09: Run/Fail: Green
Slot 12: Run/Fail: Green
Slot 14: Run/Fail: Green
Slot 17: Run/Fail: Green
Slot 24: Run/Fail: Green
Slot 25: Run/Fail: Green
Slot 30: Run/Fail: Green
Slot 33: Run/Fail: Green
Slot 40: Run/Fail: Green
The status of the two Power Filter Units (PFUs) can be viewed by entering the show power chassis command
in the Exec mode.
Checking the LED on the PFU
Each PFU has a single status LED labeled POWER.
This LED should be green for normal operating conditions.
Figure 1: PFU LED Location
The possible states for this LED are described in the following table. If the LED is not green, use the
troubleshooting information below to diagnose the problem.
ASR 5000 System Administration Guide, StarOS Release 21.2
2
host_name
show leds all
#
| Active:
| Active:
Status: Green
| Service: Off
| Active:
Status: Green
| Service: Off
| Active:
| Active:
| Active:
| Active:
| Active:
| Active:
| Active:
| Active:
Off
| Standby: Green
Green
| Standby: Off
|
Off
| Standby: Green
|
Green
| Standby: Off
Green
| Standby: Off
Green
| Standby: Off
Green
| Standby: Off
Off
| Standby: Green
Green
| Standby: Off
Off
| Standby: Off
Green
| Standby: Off
Troubleshooting