Cisco ATM Cable Interface Processor ACIP-SM(=) Kurulum ve Yapılandırma Kılavuzu - Sayfa 26
Ağ Donanımı Cisco ATM Cable Interface Processor ACIP-SM(=) için çevrimiçi göz atın veya pdf Kurulum ve Yapılandırma Kılavuzu indirin. Cisco ATM Cable Interface Processor ACIP-SM(=) 33 sayfaları. Atm cable interface processor (acip)
Sayfayı Yazdır
ACIP Error Statistics
ACIP Error Statistics
The ACIP maintains a count of certain errors. In addition to keeping a count of these errors, the ACIP
also takes a snapshot of the last VCI/VPI that caused the error. Each ACIP error counter is 16 bits.
Errors include the following:
•
•
•
•
•
•
Checking the Configuration
After configuring the new interface, use the show commands to display the status of the new
interface or all interfaces.
ATM show Commands
In addition to the show commands described in the section "Using show Commands to Verify
Interface Status," on page 19, you can use the following additional show commands to display the
current state of the ATM network and the connected VCs:
•
•
•
Following are descriptions and examples of the preceding show commands:
•
26 ATM Cable Interface Processor (ACIP) Installation and Configuration
CRC errors
Giants received
No buffers available
Framing errors
Applique/physical layer errors
Packet timeout errors on receive
To show current VCs and traffic information, use the show atm vc [vcd] command:
Specifying a VCD will display specific information about that VCD.
To show current ATM-specific information about an interface, use the show atm int interface
command:
To show current ATM traffic, use the show atm traffic command:
This command displays global traffic information to and from all ATM networks connected to
the router.
Use the show atm vc command to display the following types of statistics for all VCs:
Router# show atm vc
Interface
VCD
VPI
ATM3/0.1
1
16
ATM3/0.1
2
16
AAL /
VCI Type
Encapsulation
32
PVC
AAL5-SNAP
33
PVC
AAL5-SNAP
Peak
Avg.
Burst
Kbps
Kbps
Cells Status
8192
8192
1024 ACTIVE
8192
8192
1024 ACTIVE