Cisco Catalyst 2960-XR Donanım Kurulum Kılavuzu - Sayfa 22
Ağ Donanımı Cisco Catalyst 2960-XR için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Cisco Catalyst 2960-XR 34 sayfaları.
Ayrıca Cisco Catalyst 2960-XR için: Başlangıç Kılavuzu (25 sayfalar), Donanım Kılavuzu (20 sayfalar)
Sayfayı Yazdır
Connecting FlexStack-Extended modules (Optional)
Procedure
Step 1
Remove the dust covers from the FlexStack cables, and store them for future use.
Step 2
Insert one end of the FlexStack cable into the stack port of the first switch. Insert the other end of the cable
into the stack port on the other switch. Make sure that you insert the cables in completely until you feel them
snap into place.
Note
Step 3
Replace the dust covers when you remove the FlexStack cables from the connectors.
Caution
Connecting FlexStack-Extended modules (Optional)
Always use a Cisco-approved FlexStack cable to connect the switches.
This is only supported on the stack-capable switches.
Note
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
22
When you connect the FlexStack cable to the STACK 1 port, the tab should be above the connector.
When you connect the FlexStack cable to the STACK 2 port, the tab should be below the connector.
Removing and installing the FlexStack cable can shorten its useful life. Do not remove and insert
the cable more often than is absolutely necessary.
Switch Installation
OL-28309-02