Cisco Catalyst 2960-XR Donanım Kurulum Kılavuzu - Sayfa 6

Ağ Donanımı Cisco Catalyst 2960-XR için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Cisco Catalyst 2960-XR 34 sayfaları.
Ayrıca Cisco Catalyst 2960-XR için: Başlangıç Kılavuzu (25 sayfalar), Donanım Kılavuzu (20 sayfalar)

Cisco Catalyst 2960-XR Donanım Kurulum Kılavuzu

Planning and Installing a Switch Stack (Optional)

After a successful POST, unplug the power cord from the switch and install the switch in a rack, on a wall,
on a table, or on a shelf.
If your configuration has an RPS, connect the switch and the RPS to different AC power sources. See the
Cisco RPS documentation for information.
Note
When you connect the RPS to the switch, put the RPS in standby mode. Set the RPS to active mode during
normal operation.
Warning
Attach only the following Cisco external power system to the switch: Cisco XPS 2200 Statement 387
Planning and Installing a Switch Stack (Optional)
This section applies only to the Catalyst 2960-X and 2960-XR stacking-capable switches.
Note
Stack Guidelines
• Connect only Catalyst 2960-X or 2960-S switches in a mixed switch stack.
• Perform one of the following:
• Order the appropriate cable from your Cisco sales representative. The length of FlexStack cable depends
Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide
6
You can only create mixed stacks with Catalyst 2960-X or 2960-S switches (up to four
Note
switches). You cannot create mixed stacks with other switches. Catalyst 2960-XR
switches cannot be added to mixed stacks. They can only stack with other Catalyst
2960-XR switches.
◦ Install the FlexStack-Plus module and the FlexStack cable.
◦ Install the FlexStack-Extended Fiber module and the fiber-optic cable.
◦ Install the FlexStack-Extended Hybrid module and the required fiber-optic/FlexStack cables.
Note
All the FlexStack modules are hot-swappable and can be inserted while the switch is
powered on.
on your configuration. These are the different sizes available:
◦ CAB-STK-E-0.5M= (0.5-meter cable)
◦ CAB-STK-E-1M= (1-meter cable)
Switch Installation
OL-28309-02