Cisco Catalyst 7500 Series Manuelin Değiştirilmesi - Sayfa 5

Ağ Donanımı Cisco Catalyst 7500 Series için çevrimiçi göz atın veya pdf Manuelin Değiştirilmesi indirin. Cisco Catalyst 7500 Series 40 sayfaları. Chassis interface board
Ayrıca Cisco Catalyst 7500 Series için: Veri Sayfası (11 sayfalar), Sorun Giderme Kılavuzu (11 sayfalar), Yapılandırma Kılavuzu (50 sayfalar)

Cisco Catalyst 7500 Series Manuelin Değiştirilmesi
Replacing the CI in the Cisco 7505
The following procedures describe how to replace the CI in the Cisco 7505. Depending on your
installation, you might need to remove the Cisco 7505 from the rack in which it is installed. Figure 1
shows the interior of the Cisco 7505 at the front (noninterface processor end) of the chassis, with the
front chassis panel removed to show the internal components.
Figure 1
Chassis interface
Backplane cover
Overview of the CI Replacement in the Cisco 7505
In the Cisco 7505, the CI mounts directly to the noninterface processor side of the backplane, behind
the backplane cover. (See Figure 1.) A connector on the back of the CI plugs into a backplane socket,
and the corners of the CI butt up against four standoffs. When the backplane cover is in place, four
long Phillips screws extend through the cover, the CI, and standoffs to secure the cover and the CI
to the backplane. To replace the CI, you must remove the chassis cover panel and remove the fan
tray, power harness cover, and backplane cover.
You must remove the fan tray in order to remove the backplane cover. To remove the fan tray, you
need only remove a single M4 pan-head screw that anchors the fan tray to the interior chassis frame.
The fan tray slides into the right side of the chassis (when viewing the chassis from the noninterface
processor end).
Because the power harness cover straddles both the power supply and backplane cover, you must
remove it to access the CI. The power harness cover shields the wiring harness that delivers DC
power from the power supply to the backplane. A tab at the bottom of the cover fits into a slot in the
chassis floor; a single Phillips screw secures the top of the harness cover to the backplane cover.
The backplane cover shields the noninterface processor side of the backplane and the CI (the CI
cover is integrated with the backplane cover). Fourteen Phillips screws secure the four flanged sides
of the cover to the interior chassis frame and, near the center of the cover, two additional screws
secure the cover to two standoffs mounted to the backplane (behind the cover).
Internal Chassis Components
Power supply
handles
Power harness
cover
Replacing the Chassis Interface (CI) Board in the Cisco 7500 Series Chassis
Arbiter
Power supply
Fan tray
Replacing the CI in the Cisco 7505
5