Cisco Catalyst 8300 Series Donanım Kurulum Kılavuzu - Sayfa 36
Ağ Donanımı Cisco Catalyst 8300 Series için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Cisco Catalyst 8300 Series 46 sayfaları. Edge ucpe
Sayfayı YazdırInstalling the M.2 Storage Module
These are the steps to upgrade the M.2 storage module:
1. Power off of the system before replacing M.2.
2. Locate the M.2 storage module slot. Refer to Chassis - Front Panel to identify and locate the module.
Figure 1. M.2 storage module slot
3. Loosen the screws that secures the M.2 blank cover or existing M.2 module in the slot. Remove the blank
cover or existing module.
Note
The disk used in M.2 is also the boot disk. If you replace the M.2 disk, you must reinstall Cisco NFVIS
operating system once again.
4. Plug in the new M.2 storage module in the same location and secure it with the screws.
Figure 2. M.2 storage module slot opened
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
32
Install and Upgrade Field Replaceable Units