Cisco Cisco ASA Series Başlarken - Sayfa 9

Ağ Donanımı Cisco Cisco ASA Series için çevrimiçi göz atın veya pdf Başlarken indirin. Cisco Cisco ASA Series 31 sayfaları.
Ayrıca Cisco Cisco ASA Series için: Montaj ve Bağlantı (12 sayfalar), Montaj ve Bağlantı (6 sayfalar)

Sayfayı Yazdır
Cisco Cisco ASA Series Başlarken
Getting Started
Example:
ciscoasa# session wlan console
opening console session with module wlan
connected to module wlan. Escape character sequence is 'CTRL-^X'
ap>
Step 2
See the
access point CLI.

Configure ASDM Access

This section describes how to access ASDM with a default configuration and how to configure access if you
do not have a default configuration.

Use the Factory Default Configuration for ASDM Access (Appliances, ASAv)

With a factory default configuration, ASDM connectivity is pre-configured with default network settings.
Procedure
Connect to ASDM using the following interface and network settings:
• The management interface depends on your model:
• The default management address is:
• The clients allowed to access ASDM:
Cisco IOS Configuration Guide for Autonomous Aironet Access Points
◦ASA 5506-X, ASA 5508-X, and ASA 5516-X—The interface to which you connect to ASDM is
GigabitEthernet 1/2.
◦ASA 5512-X and higher—The interface to which you connect to ASDM is Management 0/0.
◦ASAv—The interface to which you connect to ASDM is Management 0/0.
◦ISA 3000—The interface to which you connect to ASDM is Management 1/1.
◦ASA on the Firepower 9300 chassis—The interface to which you connect to ASDM is the
Management type interface of your choice defined on the FXOS Chassis supervisor
◦ASA appliances—192.168.1.1.
◦ASAv—You set the management interface IP address during deployment.
◦ASA on the Firepower 9300 chassis—You set the management interface IP address during
deployment.
CLI Book 1: Cisco ASA Series General Operations CLI Configuration Guide, 9.5
Configure ASDM Access
for information about the
9