Cisco CWDM-GBIC-1590 Kurulum Notları - Sayfa 18

Ağ Donanımı Cisco CWDM-GBIC-1590 için çevrimiçi göz atın veya pdf Kurulum Notları indirin. Cisco CWDM-GBIC-1590 36 sayfaları. Passive optical system
Ayrıca Cisco CWDM-GBIC-1590 için: Kurulum ve Teknik Özellikler Kılavuzu (24 sayfalar)

Sayfayı Yazdır

Connecting the CWDM Passive Optical System to Your System

This section is divided into the following topics:

•

Use the CWDM passive optical system connector color codes shown in

Note

CWDM passive optical system to your system.

See

Warning

Class 1M laser radiation when open. Do not view directly with optical instruments. Statement 1053

Connecting Cables to the Dual Single-Channel OADM Module

Make sure that the CWDM GBIC or CWDM SFP transceiver color code matches the color of the OADM

Note

port to which it is connected.

To connect the cables to the dual single-channel OADM module, follow these steps (see

Insert the CWDM GBIC or CWDM SFP transceivers into the appropriate modules on your switch or

Step 1

router system if you have not already done so. For more information on CWDM SFP and CWDM GBIC

GBIC transceivers, refer to the Cisco CWDM GBIC and CWDM SFP Installation Note that accompanied

your transceivers.

Note

Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do

Warning

not view directly with optical instruments. Viewing the laser output with certain optical instruments

(for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye

hazard. Statement 1056

Cisco CWDM Passive Optical System Installation Note

Connecting Cables to the Dual Single-Channel OADM Module, page 18

Connecting Cables to the CWDM 4-Channel OADM Module, page 20

Connecting Cables to the CWDM 8-Channel Multiplexer/Demultiplexer Module, page 23

Figure 2

through

Figure 13

Always use single-mode fiber-optic patch cables to connect dual single-channel OADM ports to

the CWDM GBIC or the CWDM SFP transceivers.

CWDM GBIC transceivers are equipped with SC connectors. To make connections to the LC

connectors on the OADM modules, you must use an LC to SC patch cable (Cisco part number

CAB-SM-LCSC-1M= [1 meter cable], CAB-SM-=LCSC-5M= [5 meter cable], or an equivalent

patch cable).

for the OADM and multiplexer/demultiplexer module front panels.

Table 2

to help you connect the

Figure

17):

78-16565-02