Cisco Firepower 9300 Kurulum ve Bakım - Sayfa 6

Ağ Donanımı Cisco Firepower 9300 için çevrimiçi göz atın veya pdf Kurulum ve Bakım indirin. Cisco Firepower 9300 36 sayfaları. Installation, maintenance, and upgrade guide
Ayrıca Cisco Firepower 9300 için: Başlarken (42 sayfalar)

Sayfayı Yazdır

Remove and Replace the SSD

Step 10

Using your fingers, tighten the captive screw on the front of the security module; if using a screw driver, tighten to no

more than 3 in-lbs.

Tightening the captive screws with your fingers is unlikely to lead to stripped or damaged captive screws.

Remove and Replace the SSD

There are two SSDs in each security module. They are configured in a RAID 1 configuration. If one or both

SSDs fail, you must decommission the security module and acknowledge the slot to start the SSD installation

and update the inventory. See the "Security Module/Engine Management" chapter in the

Chassis Manager Configuration Guide

can remove the SSDs, install the new SSDs, and acknowledge the slot to bring the security module back

online.

Note

Safety Warnings

Warning

Installation, Maintenance, and Upgrade

Once you replace the SSD, the storage controller rebuilds the newly installed SSD and no loss of data

should occur. If both SSDs fail, no data can be recovered.

The two SSDs in RAID 1 store each other's data. Breaking the RAID pair to use in another service

module causes the service module to fail discovery by the Supervisor.

Take note of the following warnings:

Statement 1028 More Than One Power Supply

This unit might have more than one power supply connection. To reduce risk of electric shock,

remove all connections to de-energize the unit.

Statement 1030 Equipment Installation

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

for the instructions. After you decommission the security module, you

Installation, Maintenance, and Upgrade

Cisco FXOS Firepower