Digitrax DH165K1A Talimat Sayfası - Sayfa 4

Medya Dönüştürücü Digitrax DH165K1A için çevrimiçi göz atın veya pdf Talimat Sayfası indirin. Digitrax DH165K1A 8 sayfaları. Board replacement decoder fits kato sd40-2, ac4400 locos, ho scale, mobile decoder

Sayfayı Yazdır

RUN/STOP & FN/F0.

2. Choose AD2 for 2 digit addressing or AD4 for 4 digit addressing (DT300 &

DT400). (Ad for DT100 & DT200, see set manual for 4 digit instructions).

3. Choose the address you want to set up for the decoder.

4. Complete address programming. On DT400 press ENTER. On DT300,

DT100 & DT200 press SEL.

Note: CV29 must also be programmed to enable 4 digit addressing, this is

done automatically by the DT300 & DT400 but not on earlier throttles.

D D i i g g i i t t r r a a x x L L o o c c o o M M o o t t i i o o n n

Your locomotives look like the real thing, now you can make them run like the

real thing, too. Digitrax decoders incorporate torque compensation for smooth

as silk operation. You can also program CVs that control momentum, 3 step

and 128 step speed tables, switching speed, normal direction of travel,

scaleable speed stabilization and more to take full advantage of the Digitrax

LocoMotion System.

M M o o m m e e n n t t u u m m - - C C V V 0 0 3 3 & & C C V V 0 0 4 4

Acceleration is controlled by CV03 and deceleration by CV04. Both come

from the factory set to 000/x00. A range of 000/x00/ to 031/x1F is available for

both accel and decel. We recommend that you try CV03:003/x03 and

CV04:000/x00 as a starting point for experimenting with momentum.

S S p p e e e e d d T T a a b b l l e e s s - - H H o o w w t t h h e e L L o o c c o o R R e e s s p p o o n n d d s s t t o o t t h h e e T T h h r r o o t t t t l l e e

There are two types of speed tables: 3 Step Tables and High Resolution 28 Step

Tables. Please see your Decoder Manual for a discussion of the 28 Step Tables.

The 3 Step Tables are set up by programming 3 CVs: Start Voltage (CV02),

Mid point Voltage (CV06) and Max Voltage (CV05). These values are set at

000/x00 at the factory. All have a range of values from 000/x00 to 255/xFF. We

recommend the following CV values as a starting point for experimenting with

speed tables.

D D

C C

i i g g i i t t r r a a x x

o o m m m m a a n n d d

R R u u n n Y Y o o u u r r T T r r a a i i n n s s , , N N o o t t Y Y o o u u r r T T r r a a c c k k ! !

S S y y s s t t e e m m

www.digitrax.com

C C

o o n n t t r r o o l l