Digitrax DZ126Z1 Manuel - Sayfa 3

Medya Dönüştürücü Digitrax DZ126Z1 için çevrimiçi göz atın veya pdf Manuel indirin. Digitrax DZ126Z1 4 sayfaları. Fits azl z pa1 and others, z scale, mobile decoder, dcc board replacement, 2 fx3 functions

Sayfayı Yazdır

Customizing Your Decoder

Your Digitrax decoder is ready to run and will operate using address 03 with no

additional programming. For a more prototypical railroading experience, your

decoder can be customized for your specific locomotive by programming some of

the Configuration Variables, or CVs, available. See the Digitrax Decoder Manual

on the Digitrax web site for more information.

Changing the Decoder Address

The first CV most people change is the decoder address. This allows you to inde-

pendently control each loco with a unique address. Digitrax decoders are shipped

with CV01 (AD2) [the two digit address] set to 03. Following is a brief description

of how to change the decoder address with a Digitrax DT602 series throttle. See

your throttle Manual or system information for complete programming instruc-

tions.

Place the loco on the programming track, not to exceed 16V.

On DT602 throttle press the; MENU then 1 keys to enter Quick Decoder

Setup menu.

Press the READ key, and all the basic decoder addressing information will be

automatically displayed, after the required CV reads are completed.

The factory address will show "AD2 ShortAdr= 03" Good reads indicate the

decoder is functional and you can then edit the AD2 or AD4 LongAdr address

at this point. Press the 1 key for AD2/2 digit addressing or 2 key for AD4/4

digit addressing, and follow the scrolling directions on the DT602 display.

Note: CV29 must also be programmed to enable AD4/Long Adr/4 digit address-

ing. This is done automatically by the DT600 throttles. See your Digitrax Decoder

Manual or system manual for how to set up CV29 and other important CV's.

Digitrax Transponding CV61

The DZ126Z1 Digitrax Transponding feature is controlled by CV61. The initial

factory set value is 000 for OFF. To turn on transponding, program CV61 to a

value of 002. This allows you to use Digitrax transponding to keep track of your

rolling stock. When transponding is enabled, the front light of the locomotive will

flicker slightly to indicate transponding signal is being communicated.

— 3 —